BS EN ISO 8092-2:2005

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Test methods
  4.1 General requirements
  4.2 Visual examination
  4.3 Connection and disconnection
  4.4 Tensile strength of conductor-to-contact
       attachment
  4.5 Locking device strength
  4.6 Contact insertion force
  4.7 Contact retention in housing
  4.8 Connection resistance (voltage drop)
  4.9 Influence of water
  4.10 Temperature/humidity cycling
  4.11 Combined temperature and vibration
  4.12 Insulation resistance
  4.13 Withstand voltage
  4.14 Temperature rise
  4.15 Connector coding and polarization
  4.16 Salt spray
  4.17 Current cycling
  4.18 Thermal ageing
  4.19 Mechanical shock
  4.20 Drop
  4.21 Dust
  4.22 Rapid change of temperature (thermal shock)
  4.23 Chemical fluids
  4.24 Flowing gas corrosion
Annex A (informative) Flowing single-gas corrosion test
Annex B (informative) Cable attachment by
        insulation-displacement connection (IDC) -
        Tensile strength test
Bibliography

Defines terms, specifies requirements for test methods and gives performance guidelines for single- and multi-pole connections used with on-board electrical wiring harnesses in road vehicles. Applicable to connectors designed to be disconnected after mounting in the vehicle for repair and maintenance only.

This part of ISO8092 defines terms, and specifies test methods and general performance requirements for single-pole and multi-pole connections used with on-board electrical wiring harnesses of road vehicles.

This part of ISO8092 is applicable to connectors designed to be disconnected after mounting in the vehicle for repair and maintenance only. It does not cover one-part connections, i.e. where one part of the connection has direct contact to the pattern of the printed circuit board.

This part of ISO8092 is not applicable to internal connections of electronic devices.