BS EN ISO 2566-1:1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Steel. Conversion of elongation values Carbon and low alloy steels
Hardcopy , PDF
25-01-2022
English
15-09-1999
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
ISE/101
|
| DevelopmentNote |
Supersedes BS 3894-1(1965). (09/2005) Reviewed and confirmed by BSI, September 2007. (09/2007)
|
| DocumentType |
Standard
|
| Pages |
36
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This part of ISO2566 specifies a method of converting room temperature percentage elongations after fracture obtained on various proportional and non-proportional gauge lengths to other gauge lengths. The formula (see clause4) on which conversions are based is considered to be reliable when applied to carbon, carbon manganese, molybdenum and chromium molybdenum steels within the tensile strength range 300 to 700N/mm2 and in the hot-rolled, hot-rolled and normalized or annealed conditions, with or without tempering. These conversions are not applicable to cold reduced steels; quenched and tempered steels; austenitic steels. Neither should they be used where the gauge length exceeds 25 or where the width to thickness ratio of the test piece exceeds 20. Care should be exercised in the case of strip under 4mm thickness, as the index in the formula given in clause4 increases with decreasing thickness; the value to be used shall be the subject of agreement between the customer and the supplier.
| Standards | Relationship |
| ONORM EN ISO 2566-1 : 1999 | Identical |
| SN EN ISO 2566-1 : 1999 | Identical |
| NEN EN ISO 2566-1 : 1999 | Identical |
| NS EN ISO 2566-1 : 1ED 1999 | Identical |
| UNI EN ISO 2566-1 : 2001 | Identical |
| I.S. EN ISO 2566-1:1999 | Identical |
| UNE-EN ISO 2566-1:2000 | Identical |
| NBN EN ISO 2566-1 : 1ED 99 | Identical |
| ISO 2566-1:1984 | Identical |
| NF EN ISO 2566-1 : 1999 | Identical |
| EN ISO 2566-1:1999 | Identical |
| DIN EN ISO 2566-1:1999-09 | Identical |
| 16/30338305 DC : 0 | BS 7668 - WELDABLE STRUCTURAL STEELS - HOT FINISHED STRUCTURAL HOLLOW SECTIONS IN WEATHER RESISTANT STEELS - SPECIFICATION |
| BS 7668:2016 | Weldable structural steels. Hot finished structural hollow sections in weather resistant steels. Specification |
| BS 5400-3:2000 | Steel, concrete and composite bridges Code of practice for design of steel bridges |
| 02/703583 DC : DRAFT FEB 2002 | BS 7668 - WELDABLE STRUCTURAL STEELS - HOT FINISHED STRUCTURAL HOLLOW SECTIONS IN WEATHER RESISTANT STEELS |
| BS 5045-8:2000 | Transportable gas containers Specification for seamless aluminium alloy gas containers of water capacity 0.5 L up to 15 L and up to 300 bar charged pressure at 15°C for special portable application |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.