BS EN ISO 21003-1:2008

Introduction
1 Scope
2 Normative references
3 Terms and definitions
  3.1 Definitions related to construction
  3.2 Definitions related to geometry
  3.3 Definitions related to service conditions
  3.4 Definitions related to materials
  3.5 Definitions related to material characteristics
  3.6 Definitions related to temperature
4 Symbols and abbreviated terms
  4.1 Symbols
  4.2 Abbreviated terms
5 Classification of service conditions
6 Material
  6.1 General
  6.2 Influence on water intended for human consumption
Annex A (normative) - List of reference product standards
Bibliography

Defines the general aspects of multilayer piping systems intended to be used for hot and cold water installations inside buildings for the conveyance of water - whether or not the water is intended for human consumption (domestic systems) or heating systems - under specified design pressures and temperatures appropriate to the class of application.

This part of ISO21003 specifies the general aspects of multilayer piping systems intended to be used for hot and cold water installations inside buildings for the conveyance of water — whether or not the water is intended for human consumption (domestic systems) or heating systems — under specified design pressures and temperatures appropriate to the class of application (see Table1).

ISO21003 is a reference product standard (see 3.4.3). It is applicable to multilayer pipes, fittings, their joints, and also to joints with components made of other plastics and non-plastics materials intended to be used for hot and cold water installations. This part of ISO21003 is intended for use only in conjunction with all the other parts of ISO21003.

ISO21003 applies only to multilayer pipes with their inner layer made of plastics.

It covers a range of service conditions (application classes) and design pressures. It is not applicable for values of design temperature, T_D, maximum design temperature, T_max, and malfunction temperature, T_mal, in excess of those in Table1.

NOTE1 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.

The polymeric materials used for the stress-designed layers are the following: polybutylene (PB), polyethylene of raised temperature resistance (PE-RT), crosslinked polyethylene (PE-X), polypropylene (PP) and chlorinated poly(vinyl chloride) (PVC-C).

The PE-X used shall be fully crosslinked and shall comply with the requirements of the relevant reference product standard (ISO15875).

NOTE2 For the purposes of ISO21003, crosslinked polyethylene (PE-X) as well as adhesives are considered as thermoplastic materials.

Solid-wall pipes with thin outer layers (applied as protection layers or barrier layers, for instance) are not covered by ISO21003 but are specified in the Amendments to ISO15874-2, ISO15875-2 and ISO15876-2. The total thickness of such outer layers, including the thickness of the adhesives used, shall be≤0,4mm.