BS EN ISO 16810:2014
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Non-destructive testing. Ultrasonic testing. General principles
Hardcopy , PDF
25-10-2024
English
31-03-2014
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
Introduction
1 Scope
2 Normative references
3 Qualification and certification
of personnel
4 Information required prior
to examination
5 Principles of ultrasonic examination
6 Equipment
7 Settings
8 Preparation for examination
9 Examination
10 Characterization of imperfections
11 Examination procedure
12 Examination report
Describes the general principles required for the ultrasonic examination of industrial products that permit the transmission of ultrasound.
| Committee |
WEE/46/3
|
| DevelopmentNote |
Supersedes BS EN 583-1. (03/2014)
|
| DocumentType |
Standard
|
| Pages |
22
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This International Standard defines the general principles required for the ultrasonic examination of industrial products that permit the transmission of ultrasound.
The specific conditions of application and use of ultrasonic examination, which depend on the type of product examined, are described in documents which could include:
product standards;
specifications;
codes;
contractual documents;
written procedures.
Unless otherwise specified in the referencing documents the minimum requirements of this International Standard are applicable.
This International Standard does not define:
extent of examination and scanning plans;
acceptance criteria.
| Standards | Relationship |
| EN ISO 16810:2014 | Identical |
| ISO 16810:2012 | Identical |
| BS 8701:2016 | Full ring ovalization test for determining the susceptibility to cracking of linepipe steels in sour service. Test method |
| 16/30319903 DC : 0 | BS 8701 - FULL RING OVALIZATION TEST FOR DETERMINING THE SUSCEPTIBILITY TO CRACKING OF LINEPIPE STEELS IN SOUR SERVICE - TEST METHOD |
| ISO 16823:2012 | Non-destructive testing — Ultrasonic testing — Transmission technique |
| EN 12668-2:2010 | Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 2: Probes |
| ISO 2400:2012 | Non-destructive testing — Ultrasonic testing — Specification for calibration block No. 1 |
| ISO 9712:2012 | Non-destructive testing Qualification and certification of NDT personnel |
| EN 12668-1:2010 | Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 1: Instruments |
| ISO 16811:2012 | Non-destructive testing — Ultrasonic testing — Sensitivity and range setting |
| EN 12668-3:2013 | Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 3: Combined equipment |
| ISO 7963:2006 | Non-destructive testing — Ultrasonic testing —- Specification for calibration block No. 2 |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.