BS EN 681-3:2000

Foreword
1 Scope
2 Normative references
3 Requirements
4 Test pieces and temperature
5 Factory production control
6 Factory product control tests
7 Storage
8 Designation
9 Marking and labelling
Annex A (normative) - Determination of compression stress
Annex B (normative) - Determination of splice strength
Annex C (informative) - Guidance on storage of seals
Annex ZA (informative) - Clauses of this European Standard
                         addressing the provisions of the
                         EU Construction Products Directive

Gives the requirements for materials used in vulcanized rubber seals of cellular materials for non-pressurized drainage, sewerage and rainwater systems and non-pressure non-potable water supply (continuous flow up to 45 degree C).

This standard specifies requirements for materials used in vulcanized rubber seals of cellular materials for non-pressurized drainage, sewerage and rainwater systems and non- pressure non-potable water supply (continuous flow up to 45 °C).

General requirements for the finished joint seals are also given; any additional requirements called for by the particular application are specified in the relevant product standards taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry and pipe joint design.

This standard is applicable to joint seals for pipeline materials of vitrified clay, fibre cement, concrete, reinforced concrete, plastics and glass-reinforced plastics.

Joint seals made with an enclosed void as part of their design are included in the scope of this European Standard.