BS EN 15015:2007

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Performance requirements
  4.1 Reaction to fire
  4.2 Internal pressure strength and resistance to high
      temperature
  4.3 Dimensional tolerances
  4.4 Tightness
  4.5 Durability
  4.6 Dangerous substances
5 Test methods
  5.1 Reaction to fire
  5.2 Determination of the design pressure
  5.3 Dimensional tolerances
  5.4 Tightness and durability
6 Evaluation of conformity
  6.1 General
  6.2 Initial type testing
  6.3 Factory production control
  6.4 One-off products and products produced in very low
      quantities
Annex A (normative) Overall service (design) coefficients
      A.1 General
      A.2 Overall service (design) coefficients
Annex B (normative) Product standards for hot and cold water
        installations inside buildings
Annex C (normative) Standards for assessment of conformity
        for hot and cold water installations inside buildings
Annex ZA (informative) Clauses of this European Standard
         addressing the provisions of the EU Construction
         Products Directive (CPD)
  ZA.1 Scope and relevant characteristics
  ZA.2 Procedure for attestation of conformity of plastics pipes
       and fittings
  ZA.3 CE marking and labelling
Bibliography

Describes performance requirements for plastics pipes, fittings and their joints intended for hot and cold water installations for the conveyance of water and for heating systems with the exception of drinking water distribution for human consumption, and gives associated test methods for verification and evaluation of conformity with this European Standard.