BS 5350-C5:2002
Current
The latest, up-to-date edition.
Methods of test for adhesives Determination of bond strength in longitudinal shear for rigid adherends
Hardcopy , PDF
English
31-01-2002
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Committees responsible
Foreword
1 Scope
2 Normative references
3 Principle
4 Apparatus
5 Procedure
6 Test report
7 Expression of results
Annex A (informative) Method for determination of
moisture content of wooden slips
Bibliography
Defines the method for testing adhesives using rigid adherends that can be produced to the required dimensional tolerance and that will withstand the forces applied to them.
| Committee |
PRI/52
|
| DevelopmentNote |
Supersedes BS 5350-C5(1990) and 99/124218 DC. (02/2002) Reviewed and confirmed by BSI, May 2009. (04/2009)
|
| DocumentType |
Standard
|
| Pages |
18
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
This part of BS 5350 describes the method for testing adhesives using rigid adherends that can be produced to the required dimensional tolerances and that will withstand the forces applied to them. It is not normally applicable to the testing of joints between identical pieces of wood for which there are other, specific, standards, but may be used where wood is one adherend of an asymmetric assembly or where particular adhesives are not catered for by the specific standards. The method described in this part of BS 5350 is applicable to all types of adhesive. Although primarily intended for use in normal ambient conditions, the basic method is also applicable to testing under a wide range of temperature and other environmental conditions.
No account is taken of other mechanical properties of the adhesives or adherends that can affect the validity or usefulness of the test.
The use of a particular adherend to test an adhesive does not necessarily imply that adhesive is the one most suitable for the adherend.
This method of test is intended for ranking and quality control of adhesives and not for obtaining data for design purposes.
| BS 5214-2:1978 | Specification for testing machines for rubbers and plastics Constant rate of force application machines |
| BS L 165:1978 | Specification for sheet and strip of aluminium-coated aluminium-copper-magnesium-silicon-manganese alloy (solution treated and artificially aged) (Cu 4.4, Mg 0.5, Si 0.8, Mn 0.8) |
| BS 5214-1:1995 | Specification for testing machines for rubbers and plastics Tensile, flexural and compression types (constant rate of traverse) |
| BS EN 438-1:2016 | High-pressure decorative laminates (HPL). Sheets based on thermosetting resins (usually called laminates) Introduction and general information |
| BS 5350-E1:1976 | Methods of test for adhesives. Sampling and analysis of test data Guide to statistical analysis |
| BS 4071:1966 | Specification for polyvinyl acetate (PVA) emulsion adhesives for wood |
| BS EN 10365:2017 | Hot rolled steel channels, I and H sections. Dimensions and masses |
| BS 3544:1962 | Methods of test for polyvinyl acetate adhesives for wood |
| BS 3757:1978 | Specification for rigid PVC sheet |
| BS 1204:1993 | Specification for type MR phenolic and aminoplastic synthetic resin adhesives for wood |
| BS 5350-A1:1976 | Methods of test for adhesives. Adherends Adherend preparation |
| BS 5350-A2:1990 | Methods of test for adhesives. Adherends Guide to the selection of adherend materials |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.