ASTM F 2215 : 2002
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Balls, Bearings, Ferrous and Non-Ferrous for Use in Bearings, Valves, and Bearing Applications
Hardcopy , PDF
09-10-2018
English
10-10-2002
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
F 34
|
| DocumentType |
Standard
|
| Pages |
9
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This specification covers requirements for ferrous and nonferrous inch balls. The balls covered in this specification are intended for use in bearings, bearing applications, check valves, and other components using balls.
1.2 This is a general specification. The individual item requirements shall be as specified herein in accordance with the applicable MS sheet standards as listed in . In the event of any conflict between requirements of this specification and the MS sheet standards, the latter shall govern.
1.3 The values given in inch-pound units are to be regarded as standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
| ASTM F 2661 : 2007 : R2015 | Standard Test Method for Determining the Tribological Behavior and the Relative Lifetime of a Fluid Lubricant using the Spiral Orbit Tribometer |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.