ASTM E 777 : 2017 : REV A
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Carbon and Hydrogen in the Analysis Sample of Refuse-Derived Fuel
Hardcopy , PDF
20-04-2023
English
15-12-2017
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 11.04, 2017 Defines the determination of total carbon and hydrogen in a sample of refuse-derived fuel (RDF).
| Committee |
D 34
|
| DocumentType |
Test Method
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method is for the determination of total carbon and hydrogen in a sample of refuse-derived fuel (RDF). Both carbon and hydrogen are determined in one analysis. This test method yields the total percentages of carbon and hydrogen in RDF as analyzed and the results include not only carbon and hydrogen in the organic matter, but also the carbon present in mineral carbonates and the hydrogen present in the free moisture accompanying the analysis sample as well as hydrogen present as water of hydration.
Note 1:It is recognized that certain technical applications of the data derived from this test procedure may justify additional corrections. These corrections could involve compensation for the carbon present as carbonates, the hydrogen of free moisture accompanying the analysis sample, and the calculated hydrogen present as water of hydration.
1.2This test method may be applicable to any waste material from which a laboratory analysis sample can be prepared.
1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 8.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM E 2779 : 2010 : R2017 | Standard Test Method for Determining Particulate Matter Emissions from Pellet Heaters |
| ASTM E 870 : 1982 : R2019 | Standard Test Methods for Analysis of Wood Fuels |
| ASTM D 5681 : 2017 | Standard Terminology for Waste and Waste Management |
| ASTM E 791 : 2008 : R2016 | Standard Test Method for Calculating Refuse-Derived Fuel Analysis Data from As-Determined to Different Bases |
| ASTM D 5681 : 2008 | Standard Terminology for Waste and Waste Management |
| ASTM D 5681 : 2018 | Standard Terminology for Waste and Waste Management |
| ASTM D 1193 : 1977 : R1983 : EDT 1 | Standard Specification for Reagent Water |
| ASTM E 790 : 2015 : REDLINE | Standard Test Method for Residual Moisture in Refuse-Derived Fuel Analysis Samples |
| ASTM E 790 : 2015 | Standard Test Method for Residual Moisture in Refuse-Derived Fuel Analysis Samples |
| ASTM D 5681 : 1998 : REV A | Standard Terminology for Waste and Waste Management |
| ASTM D 5681 : 2016 | Standard Terminology for Waste and Waste Management |
| ASTM D 1193 : 2006 : R2011 | Standard Specification for Reagent Water |
| ASTM D 5681 : 2009 | Standard Terminology for Waste and Waste Management |
| ASTM E 790 : 2021 | Standard Test Method for Residual Moisture in Refuse-Derived Fuel Analysis Samples |
| ASTM E 829 : 2023 | Standard Practice for Preparing Refuse-Derived Fuel (RDF) Laboratory Samples for Analysis |
| ASTM D 1193 : 1991 | Standard Specification for Reagent Water |
| ASTM D 5681 : 1998 : REV A : EDT 1 | Standard Terminology for Waste and Waste Management |
| ASTM D 5681 : 1998 : REV A : R2004 | Standard Terminology for Waste and Waste Management |
| ASTM D 5681 : 2016 : REV A | Standard Terminology for Waste and Waste Management |
| ASTM D 5681 : 1998 : REV A : R2004 : EDT 1 | Standard Terminology for Waste and Waste Management |
| ASTM D 5681 : 2020 | Standard Terminology for Waste and Waste Management |
| ASTM E 829 : 2016 | Standard Practice for Preparing Refuse-Derived Fuel (RDF) Laboratory Samples for Analysis |
| ASTM E 791 : 2008 : R2022 | Standard Test Method for Calculating Refuse-Derived Fuel Analysis Data from As-Determined to Different Bases |
| ASTM D 1193 : 1970 | Standard Specification For Reagent Water |
| ASTM D 5681 : 2022 | Standard Terminology for Waste and Waste Management |
| ASTM D 1193 : 2006 | Standard Specification for Reagent Water |
| ASTM D 1193 : 1999 | Standard Specification for Reagent Water |
| ASTM D 5681 : 2022 : EDT 1 | Standard Terminology for Waste and Waste Management |
| ASTM D 1193 : 2006 : R2018 | Standard Specification for Reagent Water |
| ASTM D 5681 : 2013 | Standard Terminology for Waste and Waste Management |
| ASTM D 5681 : 2017-09 | TERMINOLOGY FOR WASTE AND WASTE MANAGEMENT |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.