ASTM E 1399 : 1997 : R2000
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Cyclic Movement and Measuring the Minimum and Maximum Joint Widths of Architectural Joint Systems
Hardcopy , PDF
11-11-2014
English
01-01-2000
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 04.11, 2012 Defines testing procedures for architectural joint systems.
| Committee |
E 06
|
| DocumentType |
Test Method
|
| Pages |
5
|
| ProductNote |
Reconfirmed 2000
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This test method covers testing procedures for architectural joint systems. This test method is intended for the following uses:
1.1.1 To verify movement capability information supplied to the user by the producer,
1.1.2 To standardize comparison of movement capability by relating it to specified nominal joint widths.
1.1.3 To determine the cyclic movement capability between specified minimum and maximum joint widths without visual deleterious effects, and
1.1.4 To provide the user with graphic information, drawings or pictures in the test report, depicting them at minimum, maximum, and nominal joint widths during cycling.
1.2 This test method is intended to be used only as part of a specification or acceptance criterion due to the limited movements tested.
1.3 The acceptable standard units of measure are SI units and the equivalent inch-pound units are expressed in parenthesis.
1.4 This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM E 1966 : 2015 : R2019 | Standard Test Method for Fire-Resistive Joint Systems |
| ASTM E 2837 : 2013 : R2017 | Standard Test Method for Determining the Fire Resistance of Continuity Head-of-Wall Joint Systems Installed Between Rated Wall Assemblies and Nonrated Horizontal Assemblies |
| ASTM E 631 : 2015 : REDLINE | Standard Terminology of Building Constructions |
| ASTM C 962 : 86 E1 | GUIDE FOR USE OF ELASTOMERIC JOINT SEALANTS |
| IEEE/ASTM SI_10-2010 | American National Standard for Metric Practice |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.