ASTM E 1077 : 2001 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Methods for Estimating the Depth of Decarburization of Steel Specimens
Hardcopy , PDF
11-11-2014
English
10-03-2001
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
E 04
|
| DocumentType |
Test Method
|
| Pages |
10
|
| ProductNote |
Reconfirmed EDT 1
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 These test methods cover procedures for estimating the depth of decarburization of steels irrespective of the composition, matrix microstructure, or section shape. The following basic procedures may be used:
1.1.1 Screening methods.
1.1.2 Microscopical methods.
1.1.3 Microindentation hardness methods.
1.1.4 Chemical analysis methods.
1.2 In case of a dispute, the rigorous quantitative or lineal analysis method (see 7.3.5 and 7.3.6) shall be the referee method. These methods can be employed with any cross-sectional shape. The chemical analytical methods generally reveal a greater depth of decarburization than the microscopical methods but are limited to certain simple shapes and by availability of equipment. These techniques are generally reserved for research studies. The microindentation hardness method is suitable for accurate measurements of hardened structures with relatively homogeneous microstructures.
1.3 The values stated in SI units are to be regarded as standard. The inch-pound equivalents are in parentheses and may be approximate.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM A 534 : 2017 | Standard Specification for Carburizing Steels for Anti-Friction Bearings |
| ASTM E 3 : 2011 : R2017 | Standard Guide for Preparation of Metallographic Specimens |
| ASTM A 756 : 2017 | Standard Specification for Stainless Anti-Friction Bearing Steel |
| ASTM B 848 : 2015 | Standard Specification for Powder Forged (PF) Ferrous Materials |
| ASTM A 295/A295M : 2014 | Standard Specification for High-Carbon Anti-Friction Bearing Steel |
| ASTM A 228/A228M : 2018 | Standard Specification for Steel Wire, Music Spring Quality |
| ASTM F 2282 : 2018 | Standard Specification for Quality Assurance Requirements for Carbon and Alloy Steel Wire, Rods, and Bars for Mechanical Fasteners |
| ASTM A 485 : 2017 | Standard Specification for High Hardenability Antifriction Bearing Steel |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.