Customer Support: 131 242

  • There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

ASTM E 1030/E1030M : 2015

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

Standard Practice for Radiographic Examination of Metallic Castings

Available format(s)

Hardcopy , PDF

Superseded date

03-07-2021

Language(s)

English

Published date

05-01-2016

$135.86
Including GST where applicable

This practice2provides a uniform procedure for radiographic examination of metallic castings using radiographic film as the recording medium.

Committee
E 07
DocumentType
Standard Practice
Pages
11
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

1.1This practice2 provides a uniform procedure for radiographic examination of metallic castings using radiographic film as the recording medium.

1.2This standard addresses the achievement of, or protocols for achieving, common or practical levels of radiographic coverage for castings, to detect primarily volumetric discontinuities to sensitivity levels measured by nominated image quality indicators. All departures, including alternate means or methods to increase coverage, or address challenges of detecting non-volumetric planar-type discontinuities, shall be agreed upon between the purchaser and supplier and shall consider Appendix X1 and Appendix X2.

1.3The radiographic techniques stated herein provide adequate assurance for defect detectability; however, it is recognized that, for special applications, specific techniques using more or less stringent requirements may be required than those specified. In these cases, the use of alternate radiographic techniques shall be as agreed upon between purchaser and supplier (also see Section 5).

1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F 629 : 2020 Standard Practice for Radiography of Cast Metallic Surgical Implants
ASTM F 2895 : 2020 Standard Practice for Digital Radiography of Cast Metallic Implants

ASTM E 1254 : 2013 Standard Guide for Storage of Radiographs and Unexposed Industrial Radiographic Films
ASTM E 1320 : 2015 Standard Reference Radiographs for Titanium Castings
ASTM E 1316 : 2011 : REV B Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2015 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1742 : 2000 Standard Practice for Radiographic Examination
ASTM E 1025 : 2011 Standard Practice for Design, Manufacture, and Material Grouping Classification of Hole-Type Image Quality Indicators (IQI) Used for Radiology
ASTM E 1316 : 2009 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1079 : 2005 Standard Practice for Calibration of Transmission Densitometers
ASTM E 1316 : 2008 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2010 : REV C Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2020 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2017 Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2013 : REV C Standard Terminology for Nondestructive Examinations
ASTM E 1079 : 2010 Standard Practice for Calibration of Transmission Densitometers
ASTM E 1316 : 2000 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1815 : 1996 Standard Test Method for Classification of Film Systems for Industrial Radiography
ASTM E 1316 : 2019 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2014 Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2013 : REV B Standard Terminology for Nondestructive Examinations
ASTM E 1815 : 2018 Standard Test Method for Classification of Film Systems for Industrial Radiography
ASTM E 1316 : 2018 Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2011 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2007 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2015 Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2019 : REV B Standard Terminology for Nondestructive Examinations
ASTM E 1025 : 2018 Standard Practice for Design, Manufacture, and Material Grouping Classification of Hole-Type Image Quality Indicators (IQI) Used for Radiography
ASTM E 1316 : 2013 : REV D Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2000 Standard Terminology for Nondestructive Examinations
ASTM E 1079 : 2000 Standard Practice for Calibration of Transmission Densitometers
ASTM E 1316 : 2019 Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2001 Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2003 Standard Terminology for Nondestructive Examinations
ASTM E 1742 : 2008 : REV A Standard Practice for Radiographic Examination
ASTM E 1316 : 2018 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1320 : 2010 Standard Reference Radiographs for Titanium Castings
ASTM E 1254 : 2008 Standard Guide for Storage of Radiographs and Unexposed Industrial Radiographic Films
ASTM E 1320 : 2000 Standard Reference Radiographs for Titanium Castings
ASTM E 1320 : 2010 : R2014 Standard Reference Radiographs for Titanium Castings
ASTM E 1316 : 2006 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2016 Standard Terminology for Nondestructive Examinations
ASTM E 1815 : 2008 : R2013 : EDT 1 Standard Test Method for Classification of Film Systems for Industrial Radiography
ASTM E 1316 : 2002 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1254 : 2003 Standard Guide for Storage of Radiographs and Unexposed Industrial Radiographic Films
ASTM E 1316 : 2014 : EDT 1 Standard Terminology for Nondestructive Examinations
ASTM E 1025 : 2005 Standard Practice for Design, Manufacture, and Material Grouping Classification of Hole-Type Image Quality Indicators (IQI) Used for Radiology
ASTM E 1316 : 2010 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2013 Standard Terminology for Nondestructive Examinations
ASTM E 1742 : 2005 Standard Practice for Radiographic Examination
ASTM E 1320 : 2020 Standard Reference Radiographs for Titanium Castings
ASTM E 1320 : 2005 Standard Reference Radiographs for Titanium Castings
ASTM E 1254 : 1998 Standard Guide for Storage of Radiographs and Unexposed Industrial Radiographic Films
ASTM E 1025 : 1998 Standard Practice for Design, Manufacture, and Material Grouping Classification of Hole-Type Image Quality Indicators (IQI) Used for Radiology
ASTM E 1316 : 2017 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2016 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1815 : 2008 Standard Test Method for Classification of Film Systems for Industrial Radiography
ASTM E 1316 : 2009 Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2002 Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2004 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2007 : REV C Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2010 : REV B Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2013 : REV A Standard Terminology for Nondestructive Examinations
ASTM E 1815 : 2006 Standard Test Method for Classification of Film Systems for Industrial Radiography
ASTM E 1254 : 2013 : R2018 Standard Guide for Storage of Radiographs and Unexposed Industrial Radiographic Films
ASTM E 1742 : 2006 Standard Practice for Radiographic Examination
ASTM E 1316 : 2021 Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2007 : REV B Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2005 Standard Terminology for Nondestructive Testing
ASTM E 1316 : 2004 Standard Terminology for Nondestructive Examinations
ASTM E 1079 : 2016 Standard Practice for Calibration of Transmission Densitometers
ASTM E 1316 : 2007 Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2012 Standard Terminology for Nondestructive Examinations

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.

Need help?
Call us on 131 242, then click here to start a Screen Sharing session
so we can help right away! Learn more