ASTM D 7448 : 2016
Current
The latest, up-to-date edition.
Standard Practice for Establishing the Competence of Laboratories Using ASTM Procedures in the Sampling and Analysis of Coal and Coke (Withdrawn 2024)
Hardcopy , PDF
English
28-04-2016
Important note : All end users must be registered with an Account prior to user licenses being assigned.This practice specifies requirements to operate and evaluate the quality and management systems in a laboratory that provides services with respect to sample collection, sample preparation, or testing of coal, coke, and ash derived from coal or coke using ASTM standards that are under the jurisdiction of Committee D05 on Coal and Coke.
| Committee |
D 05
|
| DocumentType |
Standard Practice
|
| Pages |
8
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
| Supersedes |
1.1This practice specifies requirements to operate and evaluate the quality and management systems in a laboratory that provides services with respect to sample collection, sample preparation, or testing of coal, coke, and ash derived from coal or coke using ASTM standards that are under the jurisdiction of Committee D05 on Coal and Coke.
Note 1:The word “laboratory” is used throughout this practice when referring to an organization that provides services in coal sampling or testing, or both. It is recognized, however, that the word may not be appropriate to an organization that does not perform actual laboratory sample testing.
1.2International standard ANSI/ISO/IEC 17025 shall be the governing document specifying requirements for management, technical competence and evaluation of a laboratory.
Note 2:An accrediting body or user of laboratory services can also impose technical or non-technical requirements not specifically addressed in ANSI/ISO/IEC 17025 provided they do not invalidate the requirements of ANSI/ISO/IEC 17025.
1.3This practice is used to evaluate only those capabilities specifically claimed by a laboratory.
1.4All percentages are percent mass fractions unless otherwise noted.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 1857/D1857M : 2018 | Standard Test Method for Fusibility of Coal and Coke Ash |
| ASTM D 8010 : 2018 | Standard Test Method for Determination of Water Soluble Alkali Content in Coal |
| ASTM D 6357 : 2011 | Test Methods for Determination of Trace Elements in Coal, Coke, & Combustion Residues from Coal Utilization Processes by Inductively Coupled Plasma Atomic Emission, Inductively Coupled Plasma Mass, & Graphite Furnace Atomic Absorption Spectrometry |
| ASTM D 5263 : 2015 | Standard Test Method for Determining the Relative Degree of Oxidation in Bituminous Coal by Alkali Extraction |
| ASTM D 5263 : 2023 | Standard Test Method for Determining the Relative Degree of Oxidation in Bituminous Coal by Alkali Extraction |
| ASTM D 6722 : 2019 | Standard Test Method for Total Mercury in Coal and Coal Combustion Residues by Direct Combustion Analysis |
| ASTM D 6357 : 2021 : REV B | Standard Test Methods for Determination of Trace Elements in Coal, Coke, and Combustion Residues from Coal Utilization Processes by Inductively Coupled Plasma Atomic Emission Spectrometry, Inductively Coupled Plasma Mass Spectrometry, and Graphite Furnace Atomic Absorption Spectrometry |
| ASTM D 5515 : 1997 : R2004 : EDT 1 | Standard Test Method for Determination of the Swelling Properties of Bituminous Coal Using a Dilatometer |
| ASTM D 4239 : 2005 | Standard Test Methods for Sulfur in the Analysis Sample of Coal and Coke Using High Temperature Tube Furnace Combustion Methods |
| ASTM D 4239 : 2013 | Standard Test Method for Sulfur in the Analysis Sample of Coal and Coke Using High-Temperature Tube Furnace Combustion |
| ASTM D 4239 : 2018 | Standard Test Method for Sulfur in the Analysis Sample of Coal and Coke Using High-Temperature Tube Furnace Combustion |
| ASTM D 3174 : 2004 : R2010 | Standard Test Method for Ash in the Analysis Sample of Coal and Coke from Coal |
| ASTM D 4239 : 1994 | Standard Test Method for Sulfur in the Analysis Sample of Coal and Coke Using High Temperature Tube Furnace Combustion Methods |
| ASTM D 4239 : 2013 : EDT 1 | Standard Test Method for Sulfur in the Analysis Sample of Coal and Coke Using High-Temperature Tube Furnace Combustion |
| ASTM D 4239 : 2000 | Standard Test Methods for Sulfur in the Analysis Sample of Coal and Coke Using High Temperature Tube Furnace Combustion Methods |
| ASTM D 6172 : 1998 : R2010 | Standard Test Method for Determining the Volume of Bulk Materials Using Contours or Cross Sections Created by Direct Operator Compilation Using Photogrammetric Procedures |
| ASTM D 5061 : 1992 : R1997 | Standard Test Method for Microscopical Determination of Volume Percent of Textural Components in Metallurgical Coke |
| ASTM D 3174 : 2002 : EDT 1 | Standard Test Method for Ash in the Analysis Sample of Coal and Coke from Coal |
| ASTM D 5515 : 2021 | Standard Test Method for Determination of the Swelling Properties of Bituminous Coal Using a Dilatometer |
| ASTM E 2554 : 2013 | Standard Practice for Estimating and Monitoring the Uncertainty of Test Results of a Test Method Using Control Chart Techniques |
| ASTM D 3174 : 2011 | Standard Test Method for Ash in the Analysis Sample of Coal and Coke from Coal |
| ASTM D 4239 : 2002 | Standard Test Methods for Sulfur in the Analysis Sample of Coal and Coke Using High Temperature Tube Furnace Combustion Methods |
| ASTM D 4749 : 1987 : R2007 | Standard Test Method for Performing the Sieve Analysis of Coal and Designating Coal Size |
| ASTM D 5515 : 1997 : R2004 : EDT 2 | Standard Test Method for Determination of the Swelling Properties of Bituminous Coal Using a Dilatometer |
| ASTM D 4239 : 2004 : REV A | Standard Test Methods for Sulfur in the Analysis Sample of Coal and Coke Using High Temperature Tube Furnace Combustion Methods |
| ASTM D 4239 : 2010 | Standard Test Methods for Sulfur in the Analysis Sample of Coal and Coke Using High-Temperature Tube Furnace Combustion Methods |
| ASTM D 3174 : 2000 | Standard Test Method for Ash in the Analysis Sample of Coal and Coke from Coal |
| ASTM D 4239 : 2014 : EDT 1 | Standard Test Method for Sulfur in the Analysis Sample of Coal and Coke Using High-Temperature Tube Furnace Combustion |
| ASTM E 2554 : 2018 : EDT 1 | Standard Practice for Estimating and Monitoring the Uncertainty of Test Results of a Test Method Using Control Chart Techniques |
| ASTM D 5515 : 2022 | Standard Test Method for Determination of the Swelling Properties of Bituminous Coal Using a Dilatometer |
| ASTM D 6172 : 1998 : EDT 1 | Standard Test Method for Determining the Volume of Bulk Materials Using Contours or Cross Sections Created by Direct Operator Compilation Using Photogrammetric Procedures |
| ASTM D 3174 : 2012 : R2018 | Standard Test Method for Ash in the Analysis Sample of Coal and Coke from Coal |
| ASTM D 3174 : 2004 | Standard Test Method for Ash in the Analysis Sample of Coal and Coke from Coal |
| ASTM D 5515 : 2017 : REV A | Standard Test Method for Determination of the Swelling Properties of Bituminous Coal Using a Dilatometer |
| ASTM D 4239 : 2017 | Standard Test Method for Sulfur in the Analysis Sample of Coal and Coke Using High-Temperature Tube Furnace Combustion |
| ASTM D 4239 : 2014 : EDT 2 | Standard Test Method for Sulfur in the Analysis Sample of Coal and Coke Using High-Temperature Tube Furnace Combustion |
| ASTM D 5515 : 2017 | Standard Test Method for Determination of the Swelling Properties of Bituminous Coal Using a Dilatometer |
| ASTM D 5515 : 2020 | Standard Test Method for Determination of the Swelling Properties of Bituminous Coal Using a Dilatometer |
| ASTM E 2554 : 2007 | Standard Practice for Estimating and Monitoring the Uncertainty of Test Results of a Test Method in a Single Laboratory Using a Control Sample Program |
| ASTM D 5061 : 2016 | Standard Test Method for Microscopical Determination of the Textural Components of Metallurgical Coke |
| ASTM D 4239 : 2004 | Standard Test Methods for Sulfur in the Analysis Sample of Coal and Coke Using High Temperature Tube Furnace Combustion Methods |
| ASTM D 121 : 2000 : EDT 1 | Standard Terminology of Coal and Coke |
| ASTM D 4239 : 2010 : EDT 1 | Standard Test Methods for Sulfur in the Analysis Sample of Coal and Coke Using High-Temperature Tube Furnace Combustion Methods |
| ASTM E 2554 : 2018 | Standard Practice for Estimating and Monitoring the Uncertainty of Test Results of a Test Method Using Control Chart Techniques |
| ASTM D 5515 : 1997 : R2010 : EDT 1 | Standard Test Method for Determination of the Swelling Properties of Bituminous Coal Using a Dilatometer |
| ASTM D 3174 : 2012 | Standard Test Method for Ash in the Analysis Sample of Coal and Coke from Coal |
| ASTM D 4749 : 1987 : R1994 : EDT 1 | Standard Test Method for Performing the Sieve Analysis of Coal and Designating Coal Size |
| ASTM D 4239 : 2008 | Standard Test Methods for Sulfur in the Analysis Sample of Coal and Coke Using High-Temperature Tube Furnace Combustion Methods |
| ASTM D 3174 : 2002 | Standard Test Method for Ash in the Analysis Sample of Coal and Coke from Coal |
| ASTM D 4749 : 1987 : R2012 | Standard Test Method for Performing the Sieve Analysis of Coal and Designating Coal Size |
| ASTM D 121 : 2001 | Standard Terminology of Coal and Coke |
| ASTM D 4239 : 2011 | Standard Test Methods for Sulfur in the Analysis Sample of Coal and Coke Using High-Temperature Tube Furnace Combustion Methods |
| ASTM D 5061 : 1992 : R2004 | Standard Test Method for Microscopical Determination of Volume Percent of Textural Components in Metallurgical Coke |
| ASTM D 5061 : 2007 | Standard Test Method for Microscopical Determination of the Textural Components of Metallurgical Coke |
| ASTM D 4239 : 2012 | Standard Test Method for Sulfur in the Analysis Sample of Coal and Coke Using High-Temperature Tube Furnace Combustion |
| ASTM D 5515 : 1997 | Standard Test Method for Determination of the Swelling Properties of Bituminous Coal Using a Dilatometer |
| ASTM D 4749 : 1987 | Standard Test Method for Performing the Sieve Analysis of Coal and Designating Coal Size |
| ASTM D 4239 : 1997 : EDT 1 | Standard Test Methods for Sulfur in the Analysis Sample of Coal and Coke Using High Temperature Tube Furnace Combustion Methods |
| ASTM D 5061 : 2019 | Standard Test Method for Microscopical Determination of the Textural Components of Metallurgical Coke |
| ASTM D 6172 : 1998 : R2004 | Standard Test Method for Determining the Volume of Bulk Materials Using Contours or Cross Sections Created by Direct Operator Compilation Using Photogrammetric Procedures |
| ASTM D 4239 : 2014 | Standard Test Method for Sulfur in the Analysis Sample of Coal and Coke Using High-Temperature Tube Furnace Combustion |
| ASTM D 4749 : 1987 : R2002 | Standard Test Method for Performing the Sieve Analysis of Coal and Designating Coal Size |
| ASTM D 5515 : 1997 : R2010 | Standard Test Method for Determination of the Swelling Properties of Bituminous Coal Using a Dilatometer |
| ASTM D 5061 : 2005 | Standard Test Method for Microscopical Determination of the Textural Components of Metallurgical Coke |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.