ASTM D 6945/D6945M : 2003 : R2017
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Emulsified Refined Coal-Tar (Ready to Use, Commercial Grade)
Hardcopy , PDF
13-01-2023
English
16-05-2017
CONTAINED IN VOL. 04.04, 2015 Defines mineral-colloid-stabilized, emulsified refined coal tar suitable for use as a weather-protective and petroleum (aliphatic) solvent resistant coating.
Committee |
D 08
|
DevelopmentNote |
Supersedes ASTM D 6945. (06/2011)
|
DocumentType |
Standard
|
Pages |
3
|
ProductNote |
Reconfirmed 2017
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
1.1This specification covers mineral-colloid-stabilized, emulsified refined coal tar suitable for use as a weather-protective and petroleum (aliphatic) solvent resistant coating. This product is typically applied to commercial lots and other low speed bituminous concrete pavements suitable for protection.
1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM D 6948/D6948M : 2003 : R2017 | Standard Practice for Application of Refined Coal Tar (Ready to Use, Commercial Grade) |
ASTM C 142 : 1997 | Standard Test Method for Clay Lumps and Friable Particles in Aggregates |
ASTM D 2939 : 2003 | Standard Test Methods for Emulsified Bitumens Used as Protective Coatings (Withdrawn 2012) |
ASTM C 136 : 2006 | Standard Test Method for Sieve Analysis of Fine and Coarse Aggregates |
ASTM D 2939 : 1998 | Standard Test Methods for Emulsified Bitumens Used as Protective Coatings |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.