ASTM D 6328 : 2018
Current
The latest, up-to-date edition.
Standard Guide for Quality Assurance Protocols for Chemical Analysis of Atmospheric Wet Deposition
Hardcopy , PDF
English
01-05-2018
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 22
|
| DocumentType |
Guide
|
| Pages |
7
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
| Supersedes |
1.1This guide describes quality assurance (QA) protocols for the determination of the anions and cations in Atmospheric Wet Deposition (AWD) shown in Table 1.
1.2Included in this guide are minimum recommended requirements for the preparation of calibration standards and suggested procedures for validating laboratory measurement results.
1.3This guide describes minimum requirements for the frequency of analysis of quality assurance samples and recommends procedures for the evaluation of quality assurance data.
1.4The guide's recommendations are based upon expected anion and cation concentrations in AWD (1)2 and Appendix X1.
1.5The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 5111 : 1999 | Standard Guide for Choosing Locations and Sampling Methods to Monitor Atmospheric Deposition at Non-Urban Locations |
| ASTM D 5015 : 2015 | Standard Test Method for pH of Atmospheric Wet Deposition Samples by Electrometric Determination |
| ASTM D 5086 : 1995 | Standard Test Method for Determination of Calcium, Magnesium, Potassium, and Sodium in Atmospheric Wet Deposition by Flame Atomic Absorption Spectrophotometry |
| ASTM D 1356 : 2015 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 5086 : 2020 | Standard Test Method for Determination of Calcium, Magnesium, Potassium, and Sodium in Atmospheric Wet Deposition by Flame Atomic Absorption Spectrophotometry |
| ASTM D 5085 : 2002 : R2013 | Standard Test Method for Determination of Chloride, Nitrate, and Sulfate in Atmospheric Wet Deposition by Chemically Suppressed Ion Chromatography |
| ASTM D 5085 : 2021 | Standard Test Method for Determination of Chloride, Nitrate, and Sulfate in Atmospheric Wet Deposition by Suppressed Ion Chromatography |
| ASTM D 5015 : 1995 | Standard Test Method for pH of Atmospheric Wet Deposition Samples by Electrometric Determination |
| ASTM D 5012 : 1989 : R1994 : EDT 1 | Standard Guide for Preparation of Materials Used for the Collection and Preservation of Atmospheric Wet Deposition |
| ASTM D 596 : 1991 : R1995 | Standard Guide for Reporting Results of Analysis of Water |
| ASTM E 200 : 2016 | Standard Practice for Preparation, Standardization, and Storage of Standard and Reagent Solutions for Chemical Analysis |
| ASTM E 200 : 2023 | Standard Practice for Preparation, Standardization, and Storage of Standard and Reagent Solutions for Chemical Analysis |
| ASTM D 5111 : 2012 : R2020 | Standard Guide for Choosing Locations and Sampling Methods to Monitor Atmospheric Deposition at Non-Urban Locations |
| ASTM D 5015 : 2015 : R2022 | Standard Test Method for pH of Atmospheric Wet Deposition Samples by Electrometric Determination |
| ASTM D 1356 : 2015 : REV A | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 3856 : 2011 : R2015 | Standard Guide for Management Systems in Laboratories Engaged in Analysis of Water (Withdrawn 2024) |
| ASTM D 3856 : 1995 : R2000 | Standard Guide for Good Laboratory Practices in Laboratories Engaged in Sampling and Analysis of Water |
| ASTM D 5085 : 1995 | Standard Test Method for Determination of Chloride, Nitrate, and Sulfate in Atmospheric Wet Deposition by Chemically Suppressed Ion Chromatography |
| ASTM D 1356 : 2000 : REV A | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1193 : 1970 | Standard Specification For Reagent Water |
| ASTM D 1356 : 2014 : REV B | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 5012 : 2020 | Standard Practice for Preparation of Materials Used for the Collection and Preservation of Atmospheric Wet Deposition |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.