ASTM D 5721 : 2008
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Air-Oven Aging of Polyolefin Geomembranes
Hardcopy , PDF
11-11-2014
English
01-07-2008
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 04.13, 2018 Defines a means for estimating the resistance of polyolefin geomembranes to thermal aging in the presence of air.
| Committee |
D 35
|
| DocumentType |
Standard Practice
|
| Pages |
3
|
| ProductNote |
Reconfirmed 2008
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This practice covers a means for estimating the resistance of polyolefin geomembranes to thermal aging in the presence of air. Only the procedure for heat exposure is specified, not the test method or specimen. The effect of heat on any particular property may be determined by selection of the appropriate test method and specimen.
1.2 This practice should be used as a guide to compare thermal aging characteristics of materials as measured by the change in some property of interest. This practice does not predict thermal aging characteristics where interactions between stress, environment, temperature, and time control failure.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 7106/D7106M : 2005 : R2015 : EDT 1 | Standard Guide for Selection of Test Methods for Ethylene Propylene Diene Terpolymer (EPDM) Geomembranes |
| ASTM D 5819 : 2018 | Standard Guide for Selecting Test Methods for Experimental Evaluation of Geosynthetic Durability |
| ASTM D 8105 : 2018 | Standard Guide for Use and Application of Geosynthetic Reinforcement Reduction Factor Test Results |
| ASTM D 1870 : 1991 | Practice for Elevated Temperature Aging Using a Tubular Oven (Withdrawn 1998) |
| ASTM D 618 : 2013 : REDLINE | Standard Practice for Conditioning Plastics for Testing |
| ASTM D 3045 : 1992 | PRACTICE FOR HEAT AGING OF PLASTICS WITHOUT LOAD |
| ASTM D 1238 : 2013 : REDLINE | Standard Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer |
| ASTM D 1790 : 2014 : REDLINE | Standard Test Method for Brittleness Temperature of Plastic Sheeting by Impact |
| ASTM D 1525 : 2017 | Standard Test Method for Vicat Softening Temperature of Plastics |
| ASTM D 4439 : 2017-08 | TERMINOLOGY FOR GEOSYNTHETICS |
| ASTM D 638 : 2014 : REDLINE | Standard Test Method for Tensile Properties of Plastics |
| ASTM D 746 : 2014 : REDLINE | Standard Test Method for Brittleness Temperature of Plastics and Elastomers by Impact |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.