ASTM D 516 : 2016
Superseded
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Sulfate Ion in Water
Available format(s)
Hardcopy , PDF
Superseded date
17-03-2023
Superseded by
Language(s)
English
Published date
23-06-2016
Important note : All end users must be registered with an Account prior to user licenses being assigned.The determination of sulfate is important because it has been reported that when this ion is present in excess of about 250 mg/L in drinking water, it causes a cathartic action (especially in children) in the presence of sodium and magnesium, and gives a bad taste to the water.
| Committee |
D 19
|
| DocumentType |
Test Method
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This turbidimetric test method covers the determination of sulfate in water in the range from 5 to 40 mg/L of sulfate ion (SO4−−).
1.2This test method was used successfully with drinking, ground, and surface waters. It is the user's responsibility to ensure the validity of this test method for waters of untested matrices.
1.3Former gravimetric and volumetric test methods have been discontinued. Refer to Appendix X1 for historical information.
1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 5752 : 2010 : R2017 | Standard Specification for Supplemental Coolant Additives (SCAs) for Use in Precharging Coolants for Heavy-Duty Engines |
| ASTM D 4692 : 2001 : R2017 | Standard Practice for Calculation and Adjustment of Sulfate Scaling Salts (CaSO<inf >4</inf>, SrSO<inf>4</inf>, and BaSO<inf>4</inf>) for Reverse Osmosis and Nanofiltration |
| ASTM E 1418 : 2021 | Standard Practice for Visible Penetrant Testing Using the Water-Washable Process |
| ASTM D 3306 : 2021 | Standard Specification for Glycol Base Engine Coolant for Automobile and Light-Duty Service |
| ASTM E 1220 : 2021 | Standard Practice for Visible Penetrant Testing Using Solvent-Removable Process |
| ASTM D 8006 : 2016 | Standard Guide for Sampling and Analysis of Residential and Commercial Water Supply Wells in Areas of Exploration and Production (E&P) Operations |
| ASTM E 1219 : 2021 | Standard Practice for Fluorescent Liquid Penetrant Testing Using the Solvent-Removable Process |
| ASTM C 375 : 2022 | Standard Classification of Water Used in Milling of Porcelain Enamel |
| ASTM D 7518 : 2020 | Standard Specification for 1,3 Propanediol (PDO) Base Engine Coolant for Automobile and Light-Duty Service |
| ASTM D 4328 : 2018 | Standard Practice for Calculation of Supersaturation of Barium Sulfate, Strontium Sulfate, and Calcium Sulfate Dihydrate (Gypsum) in Brackish Water, Seawater, and Brines |
| ASTM E 1208 : 2021 | Standard Practice for Fluorescent Liquid Penetrant Testing Using the Lipophilic Post-Emulsification Process |
| ASTM D 2010/D2010M : 1998 : R2017 | Standard Test Methods for Evaluation of Total Sulfation Activity in the Atmosphere by the Lead Dioxide Technique |
| ASTM D 7517 : 2019 | Standard Specification for Fully-Formulated 1,3 Propanediol (PDO) Base Engine Coolant for Heavy-Duty Engines |
| ASTM D 7714 : 2011 : R2021 | Standard Specification for Glycerin Base Engine Coolant for Automobile and Light-Duty Service |
| ASTM D 4130 : 2015 | Standard Test Method for Sulfate Ion in Brackish Water, Seawater, and Brines (Withdrawn 2024) |
| ASTM D 1748 : 2022 | Standard Test Method for Rust Protection by Metal Preservatives in the Humidity Cabinet |
| ASTM C 1797 : 2017 | Standard Specification for Ground Calcium Carbonate and Aggregate Mineral Fillers for use in Hydraulic Cement Concrete |
| ASTM E 1209 : 2018 | Standard Practice for Fluorescent Liquid Penetrant Testing Using the Water-Washable Process |
| ASTM D 8039 : 2016 | Standard Specification for Heat Transfer Fluids (HTF) for Heating and Air Conditioning (HVAC) Systems |
| ASTM E 1210 : 2021 | Standard Practice for Fluorescent Liquid Penetrant Testing Using the Hydrophilic Post-Emulsification Process |
| ASTM D 4985 : 2010 : R2015 | Standard Specification for Low Silicate Ethylene Glycol Base Engine Coolant for Heavy Duty Engines Requiring a Pre-Charge of Supplemental Coolant Additive (SCA) |
| ASTM G 91 : 2011 : R2018 | Standard Practice for Monitoring Atmospheric SO<inf>2</inf> Deposition Rate for Atmospheric Corrosivity Evaluation |
| ASTM D 5810 : 1996 : R2021 | Standard Guide for Spiking into Aqueous Samples |
| ASTM D 3370 : 1995 : REV A : R2003 : EDT 1 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 1129 : 2003 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2013 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2013 : R2020 | Standard Terminology Relating to Water |
| ASTM D 5847 : 1999 : REV A : EDT 1 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 5810 : 1996 : R2011 | Standard Guide for Spiking into Aqueous Samples |
| ASTM D 2777 : 2012 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 1193 : 1977 : R1983 : EDT 1 | Standard Specification for Reagent Water |
| ASTM D 5847 : 2002 : R2007 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 5810 : 1996 : R2001 | Standard Guide for Spiking into Aqueous Samples |
| ASTM D 1129 : 2006 | Standard Terminology Relating to Water |
| ASTM D 2777 : 2003 | Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water |
| ASTM D 2777 : 2021 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 1066 : 2018 | Standard Practice for Sampling Steam |
| ASTM D 3370 : 2010 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 2777 : 2013 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 1066 : 2006 | Standard Practice for Sampling Steam |
| ASTM E 275 : 2008 : R2013 | Standard Practice for Describing and Measuring Performance of Ultraviolet and Visible Spectrophotometers |
| ASTM E 275 : 2008 : R2022 | Standard Practice for Describing and Measuring Performance of Ultraviolet and Visible Spectrophotometers |
| ASTM D 5847 : 2002 : R2012 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 4327 : 2011 | Standard Test Method for Anions in Water by Suppressed Ion Chromatography |
| ASTM D 1066 : 2018 : EDT 1 | Standard Practice for Sampling Steam |
| ASTM D 2777 : 1998 | Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water |
| ASTM D 1129 : 2013 : R2020 : EDT 1 | Standard Terminology Relating to Water |
| ASTM D 3370 : 2008 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 1129 : 1999 : REV A | Standard Terminology Relating to Water |
| ASTM E 60 : 2011 : R2016 | Standard Practice for Analysis of Metals, Ores, and Related Materials by Spectrophotometry |
| ASTM D 1129 : 2006 : REV A | Standard Terminology Relating to Water |
| ASTM D 1193 : 2006 : R2011 | Standard Specification for Reagent Water |
| ASTM D 5847 : 2002 : R2020 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 1129 : 2003 : REV A | Standard Terminology Relating to Water |
| ASTM D 1129 : 2002 | Standard Terminology Relating to Water |
| ASTM D 1066 : 1997 : R2001 | Standard Practice for Sampling Steam |
| ASTM D 5810 : 1996 : R2006 | Standard Guide for Spiking into Aqueous Samples |
| ASTM D 4327 : 2003 | Standard Test Method for Anions in Water by Chemically Suppressed Ion Chromatography |
| ASTM D 1193 : 1991 | Standard Specification for Reagent Water |
| ASTM D 1066 : 2011 | Standard Practice for Sampling Steam |
| ASTM D 1129 : 2004 | Standard Terminology Relating to Water |
| ASTM D 5847 : 2022 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 2777 : 2008 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 4327 : 2017 | Standard Test Method for Anions in Water by Suppressed Ion Chromatography |
| ASTM D 4327 : 1997 | Standard Test Method for Anions in Water by Chemically Suppressed Ion Chromatography |
| ASTM D 2777 : 2006 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 3370 : 2018 | Standard Practices for Sampling Water from Flowing Process Streams |
| ASTM D 1129 : 2002 : REV A | Standard Terminology Relating to Water |
| ASTM D 5847 : 2002 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 3370 : 1976 | Standard Practices for Sampling Water |
| ASTM E 60 : 2011 : R2022 : EDT 1 | Standard Practice for Analysis of Metals, Ores, and Related Materials by Spectrophotometry |
| ASTM D 1193 : 1970 | Standard Specification For Reagent Water |
| ASTM D 1193 : 2006 | Standard Specification for Reagent Water |
| ASTM D 3370 : 1995 : REV A : R1999 : EDT 1 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 1193 : 1999 | Standard Specification for Reagent Water |
| ASTM D 1129 : 2010 | Standard Terminology Relating to Water |
| ASTM D 5810 : 1996 | Standard Guide for Spiking into Aqueous Samples |
| ASTM D 3370 : 2007 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 1129 : 2006 : REV A : EDT 1 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2001 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2004 : EDT 1 | Standard Terminology Relating to Water |
| ASTM D 1193 : 2006 : R2018 | Standard Specification for Reagent Water |
| ASTM D 2777 : 2008 : EDT 1 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 5810 : 1996 : R2015 | Standard Guide for Spiking into Aqueous Samples |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.