ASTM D 5118/D5118M : 2025

1.1This practice covers the fabrication of new fiberboard boxes, liners, and sleeves.

1.2This practice points out the factors and components that must be controlled in the manufacture of corrugated and solid fiberboard boxes, liners, and sleeves.

1.3This practice does not directly cover the adequacy of fiberboard containers under all conditions of exposure to atmosphere, handling, shipping, and storage. However, references regarding how to assess the adequacy of container under these conditions are included in the practice.

1.4The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.