ASTM D 4626 : 1995 : R2000
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Calculation of Gas Chromatographic Response Factors
Hardcopy , PDF
11-11-2014
English
10-04-2000
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 05.02, 2015 Defines a procedure for calculating gas chromatographic response factors.
| Committee |
D 02
|
| DocumentType |
Standard Practice
|
| Pages |
3
|
| ProductNote |
Reconfirmed 2000
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This practice describes a procedure for calculating gas chromatographic response factors. It is applicable to chromatographic data obtained from a gaseous mixture or from any mixture of compounds that is normally liquid at room temperature and pressure or solids, or both, that will form a solution with liquids. It is not intended to be applied to those compounds that react in the chromatograph or are not quantitatively eluted. Normal C 6 through C 11 paraffins have been chosen as model compounds for demonstration purposes.
1.2 The values stated in SI units are to be regarded as the standard. The values stated in inch-pound units are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 7493 : 2014 : R2018 | Standard Test Method for Online Measurement of Sulfur Compounds in Natural Gas and Gaseous Fuels by Gas Chromatograph and Electrochemical Detection |
| ASTM D 6843 : 2010 : R2015 | Standard Test Method for Silanes Used in Rubber Formulations <brk/>(bis-(triethoxysilylpropyl)sulfanes): Characterization by Gas Chromatography (GC) |
| ASTM D 6417 : 2015 | Standard Test Method for Estimation of Engine Oil Volatility by Capillary Gas Chromatography |
| ASTM D 6228 : 2019 | Standard Test Method for Determination of Sulfur Compounds in Natural Gas and Gaseous Fuels by Gas Chromatography and Flame Photometric Detection |
| ASTM D 6968 : 2003 : R2015 | Standard Test Method for Simultaneous Measurement of Sulfur Compounds and Minor Hydrocarbons in Natural Gas and Gaseous Fuels by Gas Chromatography and Atomic Emission Detection (Withdrawn 2024) |
| ASTM D 5441 : 1998 : R2017 | Standard Test Method for Analysis of Methyl Tert-Butyl Ether (MTBE) by Gas Chromatography |
| ASTM D 5623 : 2019 | Standard Test Method for Sulfur Compounds in Light Petroleum Liquids by Gas Chromatography and Sulfur Selective Detection |
| ASTM D 7807 : 2012 | Standard Test Method for Determination of Boiling Range Distribution of Hydrocarbon and Sulfur Components of Petroleum Distillates by Gas Chromatography and Chemiluminescence Detection |
| ASTM D 7798 : 2015 | Standard Test Method for Boiling Range Distribution of Petroleum Distillates with Final Boiling Points up to 538 °C by Ultra Fast Gas Chromatography (UF GC) |
| ASTM D 5501 : 2012 : R2016 | Standard Test Method for Determination of Ethanol and Methanol Content in Fuels Containing Greater than 20% Ethanol by Gas Chromatography |
| ASTM D 7164 : 2010 : R2015 | Standard Practice for On-line/At-line Heating Value Determination of Gaseous Fuels by Gas Chromatography |
| ASTM D 2887 : 2019 | Standard Test Method for Boiling Range Distribution of Petroleum Fractions by Gas Chromatography |
| ASTM D 7096 : 2019 | Standard Test Method for Determination of the Boiling Range Distribution of Gasoline by Wide-Bore Capillary Gas Chromatography |
| ASTM D 7796 : 2017 | Standard Test Method for Analysis of Ethyl tert-Butyl Ether (ETBE) by Gas Chromatography |
| ASTM D 7213 : 2015 | Standard Test Method for Boiling Range Distribution of Petroleum Distillates in the Boiling Range from 100 °C to 615 °C by Gas Chromatography |
| ASTM D 7800/D7800M : 2014 | Standard Test Method for Determination of Elemental Sulfur in Natural Gas (Withdrawn 2023) |
| ASTM D 5442 : 2017 | Standard Test Method for Analysis of Petroleum Waxes by Gas Chromatography |
| ASTM D 7920 : 2015 : EDT 1 | Standard Test Method for Determination of Fuel Methanol (M99) and Methanol Fuel Blends (M10 to M99) by Gas Chromatography |
| ASTM D 7398 : 2011 : R2016 | Standard Test Method for Boiling Range Distribution of Fatty Acid Methyl Esters (FAME) in the Boiling Range from 100 °C to 615 °C by Gas Chromatography |
| ASTM D 7165 : 2010 : R2015 | Standard Practice for Gas Chromatograph Based On-line/At-line Analysis for Sulfur Content of Gaseous Fuels |
| ASTM D 6730 : 2001 : R2016 | Standard Test Method for Determination of Individual Components in Spark Ignition Engine Fuels by 100–Metre Capillary (with Precolumn) High-Resolution Gas Chromatography |
| ASTM D 6352 : 2015 | Standard Test Method for Boiling Range Distribution of Petroleum Distillates in Boiling Range from 174 °C to 700 °C by Gas Chromatography |
| ASTM D 2804 : 2002 : R2012 | Standard Test Method for Purity of Methyl Ethyl Ketone By Gas Chromatography (Withdrawn 2021) |
| ASTM D 3524 : 2014 | Standard Test Method for Diesel Fuel Diluent in Used Diesel Engine Oils by Gas Chromatography |
| ASTM D 7875 : 2014 | Standard Test Method for Determination of Butanol and Acetone Content of Butanol for Blending with Gasoline by Gas Chromatography |
| ASTM D 3362 : 2005 | Standard Test Method for Purity of Acrylate Esters by Gas Chromatography (Withdrawn 2011) |
| ASTM E 260 : 1996 | Standard Practice for Packed Column Gas Chromatography |
| ASTM D 4307 : 2017 : REDLINE | Standard Practice for Preparation of Liquid Blends for Use as Analytical Standards |
| ASTM D 3465 : 2014 : REDLINE | Standard Test Method for Purity of Monomeric Plasticizers by Gas Chromatography |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.