ASTM D 4491/D4491M : 2022
Current
The latest, up-to-date edition.
Standard Test Methods for Water Permeability of Geotextiles by Permittivity
Hardcopy , PDF
English
01-06-2022
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 35
|
| DocumentType |
Test Method
|
| Pages |
8
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
| Supersedes |
1.1These test methods cover procedures for determining the hydraulic conductivity (water permeability) of geotextiles in terms of permittivity under standard testing conditions, in the uncompressed state. Included are three procedures: the constant head and falling head methods using a water flow apparatus, and the air flow method using an air flow apparatus.
1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 5494 : 1993 : R2018 | Standard Test Method for the Determination of Pyramid Puncture Resistance of Unprotected and Protected Geomembranes |
| ASTM D 7273/D7273M : 2008 : R2020 | Standard Guide for Acceptance Testing Requirements for Geonets and Geonet Drainage Geocomposites |
| ASTM D 1987 : 2022 | Standard Test Method for Biological Clogging of Geotextile, Drainage Geocomposites, or Soil/Geotextile Filters |
| ASTM D 5493 : 2006 : R2016 | Standard Test Method for Permittivity of Geotextiles Under Load |
| ASTM D 6461/D6461M : 2022 | Standard Specifications for Silt Fence Materials |
| ASTM E 2777 : 2020 | Standard Guide for Vegetative (Green) Roof Systems |
| ASTM D 5567 : 1994 : R2018 | Standard Test Method for Hydraulic Conductivity Ratio (HCR) Testing of Soil/Geotextile Systems |
| ASTM D 4439 : 2020 | Standard Terminology for Geosynthetics |
| ASTM D 6636 : 2001 : R2018 | Standard Test Method for Determination of Ply Adhesion Strength of Reinforced Geomembranes |
| ASTM D 5886 : 1995 : R2018 | Standard Guide for Selection of Test Methods to Determine Rate of Fluid Permeation Through Geomembranes for Specific Applications |
| ASTM D 7001 : 2020 | Standard Specification for Geocomposites for Pavement Edge Drains and Other High-Flow Applications |
| ASTM D 6917 : 2016 : R2022 | Standard Guide for Selection of Test Methods for Prefabricated Vertical Drains (PVD) |
| ASTM D 5885/D5885M : 2020 | Standard Test Method for Oxidative Induction Time of Polyolefin Geosynthetics by High-Pressure Differential Scanning Calorimetry |
| ASTM D 4716/D4716M : 2020 | Standard Test Method for Determining the (In-plane) Flow Rate per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head |
| ASTM D 7351/D7351M : 2021 | Standard Test Method for Determination of Sediment Retention Device (SRD) Effectiveness in Sheet Flow Applications |
| ASTM D 5820 : 1995 : R2018 | Standard Practice for Pressurized Air Channel Evaluation of Dual-Seamed Geomembranes |
| ASTM D 6365 : 1999 : R2018 | Standard Practice for Nondestructive Testing of Geomembrane Seams Using the Spark Test |
| ASTM D 6707/D6707M : 2006 : R2019 | Standard Specification for Circular-Knit Geotextile for Use in Subsurface Drainage Applications |
| ASTM D 653 : 2024 | Standard Terminology Relating to Soil, Rock, and Contained Fluids |
| ASTM D 123 : 2019 | Standard Terminology Relating to Textiles |
| ASTM E 691 : 2023 | Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method |
| ASTM D 4439 : 2024 : REV A | Standard Terminology for Geosynthetics |
| ASTM D 653 : 2022 | Standard Terminology Relating to Soil, Rock, and Contained Fluids |
| ASTM E 691 : 2022 | Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method |
| ASTM D 4439 : 2024 : EDT 1 | Standard Terminology for Geosynthetics |
| ASTM D 4439 : 2024 | Standard Terminology for Geosynthetics |
| ASTM D 653 : 2021 : REV B | Standard Terminology Relating to Soil, Rock, and Contained Fluids |
| ASTM E 691 : 2021 | Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method |
| ASTM D 4439 : 2023 : REV A | Standard Terminology for Geosynthetics |
| ASTM D 4439 : 2023 : REV B | Standard Terminology for Geosynthetics |
| ASTM D 123 : 2023 | Standard Terminology Relating to Textiles |
| ASTM D 653 : 2024 : REV A | Standard Terminology Relating to Soil, Rock, and Contained Fluids |
| ASTM D 4439 : 2023 | Standard Terminology for Geosynthetics |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.