ASTM D 3549/D3549M : 2018 : R2023
Current
The latest, up-to-date edition.
Standard Test Method for Thickness or Height of Compacted Asphalt Mixture Specimens
Hardcopy , PDF
English
04-05-2023
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 04
|
| DocumentType |
Test Method
|
| Pages |
4
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
| Supersedes |
1.1This test method covers determination of the thickness (or height) of compacted asphalt mixture specimens.
1.2Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.2.1Section 7.4 specifies SI units because they are the units used in the equations for Test Methods D1188/D1188M and D2726/D2726M. Performing calculations without first converting any measurements made in inch-pound units to SI units in 7.4 will result in nonconformance with the standard.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 6927 : 2022 | Standard Test Method for Marshall Stability and Flow of Asphalt Mixtures |
| ASTM D 4867/D4867M : 2022 | Standard Test Method for Effect of Moisture on Asphalt Mixtures |
| ASTM D 8237 : 2021 | Standard Test Method for Determining Fatigue Failure of Asphalt-Aggregate Mixtures with the Four-Point Beam Fatigue Device |
| ASTM D 3203 : 2022 | Standard Test Method for Percent Air Voids in Compacted Asphalt Mixtures |
| ASTM D 8458 : 2022 | Standard Test Method for Evaluation of Fatigue Performance of Asphalt Mixtures Using the Three-Point Bending Cylinder (3PBC) Test |
| ASTM D 6931 : 2017 | Standard Test Method for Indirect Tensile (IDT) Strength of Asphalt Mixtures |
| ASTM D 8303 : 2020 | Standard Test Method for Determining Thermal Cracking Properties of Asphalt Mixtures Through Measurement of Thermally Induced Stress and Strain |
| ASTM D 8541 : 2023 | Standard Test Method for Determination of Relative Rotation to Evaluate the Workability of Asphalt Mixture Using Wireless Particle-Size Sensors |
| ASTM D 3666 : 2016 | Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials |
| ASTM D 3666 : 2024 | Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.