ASTM D 2172 : 2001 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Methods for Quantitative Extraction of Bitumen From Bituminous Paving Mixtures
Hardcopy , PDF
11-11-2014
English
10-12-2001
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 04
|
| DocumentType |
Test Method
|
| Pages |
12
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 These test methods cover the quantitative determination of bitumen in hot-mixed paving mixtures and pavement samples. Aggregate obtained by these test methods may be used for sieve analysis using Test Method C 117 and Test Method C 136.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards are given in Section 7.
Note 1—The results obtained by these test methods may be affected by the age of the material tested, with older samples tending to yield slightly lower bitumen content. Best quantitative results are obtained when the test is made on mixtures and pavements shortly after their preparation. It is difficult to remove all the asphalt when some aggregates are used and some chlorides may remain within the mineral matter affecting the measured asphalt content.
| ASTM D 4887/D4887M : 2011 : R2016 | Standard Practice for Preparation of Viscosity Blends for Hot Recycled Asphalt Materials |
| ASTM D 5444 : 2015 | Standard Test Method for Mechanical Size Analysis of Extracted Aggregate |
| ASTM D 4469 : 2017 | Standard Practice for Calculating Percent Asphalt Absorption by the Aggregate in Asphalt Mixtures |
| ASTM D 1856 : 2009 : R2015 | Standard Test Method for Recovery of Asphalt From Solution by Abson Method |
| ASTM D 6607 : 2000 : R2015 | Standard Practice for Inclusion of Precision Statement Variation in Specification Limits |
| ASTM D 5710/D5710M : 2015 | Standard Specification for Trinidad Lake Modified Asphalt |
| ASTM D 4057 : 2012 : R2018 | Standard Practice for Manual Sampling of Petroleum and Petroleum Products |
| ASTM D 6608 : 2012 | Standard Practice for the Identification of Trinidad Lake Asphalt in Asphalt Mixes |
| ASTM D 4215 : 2007 : R2013 | Standard Specification for Cold-Mixed, Cold-Laid Bituminous Paving Mixtures |
| ASTM D 6995 : 2005 : R2013 | Standard Test Method for Determining Field VMA based on the Maximum Specific Gravity of the Mix (G<inf>mm</inf>) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.