ASTM D 1179 : 2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Methods for Fluoride Ion in Water
Hardcopy , PDF
06-01-2022
English
24-06-2016
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 19
|
| DocumentType |
Test Method
|
| Pages |
7
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1These test methods2 cover the determination of fluoride ion in water. The following two test methods are given:
| Sections | |
| Test Method A—Distillation | 7 to 13 |
| Test Method B—Ion Selective Electrode | 14 to 21 |
1.2Test Method A covers the accurate measurement of total fluoride in water through isolation of the fluoride by distillation and subsequent measurement in the distillate by use of the ion selective electrode (ISE) method. The procedure covers the range from 0.1 to 2.6 mg/L of fluoride.
1.3Test Method B covers the accurate measurement of simple fluoride ion in water by means of an ion selective electrode. With this test method, distillation is eliminated because the electrode is not affected by the interferences common to colorimetric procedures. Concentrations of fluoride from 0.1 to 1000 mg/L may be measured.
1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see 12.1.2.
1.6Former Test Method A, SPADNS Photometric Procedure, was discontinued. Refer to Appendix X1 for historical information.
| ASTM E 800 : 2020 | Standard Guide for Measurement of Gases Present or Generated During Fires |
| ASTM F 2168 : 2013 : R2019 | Standard Specification for Packing Material, Graphitic, Corrugated Ribbon or Textured Tape, and Die-Formed Ring |
| ASTM F 2191/F2191M : 2013 : R2020 : EDT 1 | Standard Specification for Packing Material, Graphitic or Carbon Braided Yarn |
| ASTM D 5091 : 1995 : R2014 | Standard Guide for Water Analysis for Electrodialysis/Electrodialysis Reversal Applications (Withdrawn 2023) |
| ASTM D 4195 : 2008 : R2014 | Standard Guide for Water Analysis for Reverse Osmosis and Nanofiltration Application (Withdrawn 2023) |
| ASTM F 2191/F2191M : 2013 | Standard Specification for Packing Material, Graphitic or Carbon Braided Yarn |
| ASTM F 2168 : 2013 | Standard Specification for Packing Material, Graphitic, Corrugated Ribbon or Textured Tape, and Die-Formed Ring |
| ASTM D 5810 : 1996 : R2021 | Standard Guide for Spiking into Aqueous Samples |
| ASTM D 3370 : 1995 : REV A : R2003 : EDT 1 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 1129 : 2003 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2013 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2013 : R2020 | Standard Terminology Relating to Water |
| ASTM D 5847 : 1999 : REV A : EDT 1 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 4127 : 1992 : R1996 | Standard Terminology Used with Ion-Selective Electrodes |
| ASTM D 5810 : 1996 : R2011 | Standard Guide for Spiking into Aqueous Samples |
| ASTM D 2777 : 2012 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 1193 : 1977 : R1983 : EDT 1 | Standard Specification for Reagent Water |
| ASTM D 5847 : 2002 : R2007 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 5810 : 1996 : R2001 | Standard Guide for Spiking into Aqueous Samples |
| ASTM D 4127 : 2012 | Standard Terminology Used with Ion-Selective Electrodes |
| ASTM D 1129 : 2006 | Standard Terminology Relating to Water |
| ASTM D 2777 : 2003 | Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water |
| ASTM D 1066 : 2018 | Standard Practice for Sampling Steam |
| ASTM D 3370 : 2010 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 2777 : 2013 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 1066 : 2006 | Standard Practice for Sampling Steam |
| ASTM D 5847 : 2002 : R2012 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 1066 : 2018 : EDT 1 | Standard Practice for Sampling Steam |
| ASTM D 2777 : 1998 | Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water |
| ASTM D 3370 : 2008 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 1129 : 1999 : REV A | Standard Terminology Relating to Water |
| ASTM D 1129 : 2006 : REV A | Standard Terminology Relating to Water |
| ASTM D 1193 : 2006 : R2011 | Standard Specification for Reagent Water |
| ASTM D 5847 : 2002 : R2020 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 1129 : 2003 : REV A | Standard Terminology Relating to Water |
| ASTM D 1129 : 2002 | Standard Terminology Relating to Water |
| ASTM D 4127 : 2006 | Standard Terminology Used with Ion-Selective Electrodes |
| ASTM D 1066 : 1997 : R2001 | Standard Practice for Sampling Steam |
| ASTM D 5810 : 1996 : R2006 | Standard Guide for Spiking into Aqueous Samples |
| ASTM D 4127 : 2018 | Standard Terminology Used with Ion-Selective Electrodes |
| ASTM D 1193 : 1991 | Standard Specification for Reagent Water |
| ASTM D 1066 : 2011 | Standard Practice for Sampling Steam |
| ASTM D 1129 : 2004 | Standard Terminology Relating to Water |
| ASTM D 2777 : 2008 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 2777 : 2006 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 3370 : 2018 | Standard Practices for Sampling Water from Flowing Process Streams |
| ASTM D 1129 : 2002 : REV A | Standard Terminology Relating to Water |
| ASTM D 5847 : 2002 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 3370 : 1976 | Standard Practices for Sampling Water |
| ASTM D 1193 : 1970 | Standard Specification For Reagent Water |
| ASTM D 1193 : 2006 | Standard Specification for Reagent Water |
| ASTM D 3370 : 1995 : REV A : R1999 : EDT 1 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 1193 : 1999 | Standard Specification for Reagent Water |
| ASTM D 1129 : 2010 | Standard Terminology Relating to Water |
| ASTM D 5810 : 1996 | Standard Guide for Spiking into Aqueous Samples |
| ASTM D 3370 : 2007 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 1129 : 2006 : REV A : EDT 1 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2001 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2004 : EDT 1 | Standard Terminology Relating to Water |
| ASTM D 4127 : 2002 | Standard Terminology Used with Ion-Selective Electrodes |
| ASTM D 4127 : 2018 : REV A | Standard Terminology Used with Ion-Selective Electrodes |
| ASTM D 1193 : 2006 : R2018 | Standard Specification for Reagent Water |
| ASTM D 2777 : 2008 : EDT 1 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 5810 : 1996 : R2015 | Standard Guide for Spiking into Aqueous Samples |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.