ASTM D 1126 : 2017
Current
The latest, up-to-date edition.
Standard Test Method for Hardness in Water
Hardcopy , PDF
English
15-12-2017
Important note : All end users must be registered with an Account prior to user licenses being assigned.This test method covers the determination of hardness in water by titration.
| Committee |
D 19
|
| DocumentType |
Test Method
|
| Pages |
4
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
| Supersedes |
1.1This test method covers the determination of hardness in water by titration. This test method is applicable to waters that are clear in appearance and free of chemicals that will complex calcium or magnesium. The lower detection limit of this test method is approximately 2 to 5 mg/L as CaCO3; the upper limit can be extended to all concentrations by sample dilution. It is possible to differentiate between hardness due to calcium ions and that due to magnesium ions by this test method.
1.2This test method was tested on reagent water only. It is the user's responsibility to ensure the validity of the test method for waters of untested matrices.
1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM E 1673 : 1996 : R2017 | Standard Test Method for Percent Suspensibility |
| ASTM D 4985 : 2010 : R2015 | Standard Specification for Low Silicate Ethylene Glycol Base Engine Coolant for Heavy Duty Engines Requiring a Pre-Charge of Supplemental Coolant Additive (SCA) |
| ASTM D 7714 : 2011 : R2016 : EDT 1 | Standard Specification for Glycerin Base Engine Coolant for Automobile and Light-Duty Service |
| ASTM D 7715 : 2012 : R2016 : EDT 1 | Standard Specification for Fully-Formulated Glycerin Base Engine Coolant for Heavy-Duty Engines |
| ASTM D 6469 : 2017 | Standard Guide for Microbial Contamination in Fuels and Fuel Systems |
| ASTM D 5752 : 2010 : R2017 | Standard Specification for Supplemental Coolant Additives (SCAs) for Use in Precharging Coolants for Heavy-Duty Engines |
| ASTM D 3342 : 1990 : R2017 | Standard Test Method for Dispersion Stability of New (Unused) Rolling Oil Dispersions in Water |
| ASTM D 2946 : 2001 : R2018 | Standard Terminology for Asbestos and Asbestos–Cement Products (Withdrawn 2022) |
| ASTM D 7518 : 2010 : R2015 : EDT 1 | Standard Specification for 1,3 Propanediol (PDO) Base Engine Coolant for Automobile and Light-Duty Service |
| ASTM D 3306 : 2019 | Standard Specification for Glycol Base Engine Coolant for Automobile and Light-Duty Service |
| ASTM E 1910/E1910M : 2015 | Standard Test Method for Agricultural pH Control Agents, Measurement of pH Change and Buffering Capacity |
| ASTM E 1945 : 2002 : R2016 | Standard Test Method for Percent Dispersibility |
| ASTM C 500/C500M : 2007 : R2019 | Standard Test Methods for Asbestos-Cement Pipe (Withdrawn 2022) |
| ASTM D 1782 : 2017 | Standard Test Methods for Operating Performance of Particulate Cation-Exchange Materials |
| ASTM E 1116 : 1998 : R2014 | Standard Test Method for Emulsification Characteristics of Pesticide Emulsifiable Concentrates |
| ASTM D 3376 : 2018 | Standard Test Methods of Sampling and Testing Pulps to be Used in the Manufacture of Electrical Insulation |
| ASTM E 1391 : 2003 : R2014 | Standard Guide for Collection, Storage, Characterization, and Manipulation of Sediments for Toxicological Testing and for Selection of Samplers Used to Collect Benthic Invertebrates |
| ASTM D 7517 : 2019 | Standard Specification for Fully-Formulated 1,3 Propanediol (PDO) Base Engine Coolant for Heavy-Duty Engines |
| ASTM D 6210 : 2017 | Standard Specification for Fully-Formulated Glycol Base Engine Coolant for Heavy-Duty Engines<rangeref></rangeref > |
| ASTM D 8039 : 2016 | Standard Specification for Heat Transfer Fluids (HTF) for Heating and Air Conditioning (HVAC) Systems |
| ASTM C 375 : 1958 : R2016 | Standard Classification of Water Used in Milling of Porcelain Enamel |
| ASTM D 3370 : 1995 : REV A : R2003 : EDT 1 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 1129 : 2003 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2013 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2013 : R2020 | Standard Terminology Relating to Water |
| ASTM D 5847 : 1999 : REV A : EDT 1 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 2777 : 2012 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 1129 : 2013 : R2020 : EDT 2 | Standard Terminology Relating to Water |
| ASTM D 1193 : 1977 : R1983 : EDT 1 | Standard Specification for Reagent Water |
| ASTM D 5847 : 2002 : R2007 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 1129 : 2006 | Standard Terminology Relating to Water |
| ASTM D 2777 : 2003 | Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water |
| ASTM D 2777 : 2021 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 1066 : 2018 | Standard Practice for Sampling Steam |
| ASTM D 3370 : 2010 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 2777 : 2013 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 1066 : 2006 | Standard Practice for Sampling Steam |
| ASTM D 5847 : 2002 : R2012 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 1066 : 2018 : EDT 1 | Standard Practice for Sampling Steam |
| ASTM D 2777 : 1998 | Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water |
| ASTM D 1129 : 2013 : R2020 : EDT 1 | Standard Terminology Relating to Water |
| ASTM D 3370 : 2008 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 1129 : 1999 : REV A | Standard Terminology Relating to Water |
| ASTM D 1129 : 2006 : REV A | Standard Terminology Relating to Water |
| ASTM D 1193 : 2006 : R2011 | Standard Specification for Reagent Water |
| ASTM D 5847 : 2002 : R2020 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 1129 : 2003 : REV A | Standard Terminology Relating to Water |
| ASTM D 1129 : 2002 | Standard Terminology Relating to Water |
| ASTM D 1066 : 1997 : R2001 | Standard Practice for Sampling Steam |
| ASTM D 1193 : 1991 | Standard Specification for Reagent Water |
| ASTM D 1066 : 2011 | Standard Practice for Sampling Steam |
| ASTM D 1129 : 2004 | Standard Terminology Relating to Water |
| ASTM D 5847 : 2022 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 2777 : 2008 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 2777 : 2006 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 3370 : 2018 | Standard Practices for Sampling Water from Flowing Process Streams |
| ASTM D 1129 : 2002 : REV A | Standard Terminology Relating to Water |
| ASTM D 5847 : 2002 | Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis |
| ASTM D 3370 : 1976 | Standard Practices for Sampling Water |
| ASTM D 1193 : 1970 | Standard Specification For Reagent Water |
| ASTM D 1193 : 2006 | Standard Specification for Reagent Water |
| ASTM D 3370 : 1995 : REV A : R1999 : EDT 1 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 1193 : 1999 | Standard Specification for Reagent Water |
| ASTM D 1129 : 2010 | Standard Terminology Relating to Water |
| ASTM D 3370 : 2007 | Standard Practices for Sampling Water from Closed Conduits |
| ASTM D 1129 : 2006 : REV A : EDT 1 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2001 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2004 : EDT 1 | Standard Terminology Relating to Water |
| ASTM D 1193 : 2006 : R2018 | Standard Specification for Reagent Water |
| ASTM D 2777 : 2008 : EDT 1 | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.