ASTM C 1615/C1615M : 2017

1.1.1The intent of this standard is to provide general guidelines for the design, selection, quality assurance, installation, operation, and maintenance of mechanical drive systems used in remote hot cell environments. The term mechanical drive systems used herein, encompasses all individual components used for imparting motion to equipment systems, subsystems, assemblies, and other components. It also includes complete positioning systems and individual units that provide motive power and any position indicators necessary to monitor the motion.

1.2.1This standard is intended to be applicable to equipment used under one or more of the following conditions:

1.2.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3.1This standard is not a substitute for applied engineering skills, proven practices and experience. Its purpose is to provide guidance.

1.3.2This standard does not supersede federal or state regulations, or both, and codes applicable to equipment under any conditions.

1.3.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.