ASTM B 816 : 2000 : R2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Coatings of Cadmium-Zinc Mechanically Deposited
Hardcopy , PDF
29-06-2021
English
07-04-2015
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 02.05, 2017 Describes the requirements for a coating that is a mixture of cadmium and zinc deposited on metallic products by mechanical deposition.
| Committee |
B 08
|
| DocumentType |
Standard
|
| Pages |
6
|
| ProductNote |
Reconfirmed 2015
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1General—This specification covers the requirements for a coating that is a mixture of cadmium and zinc deposited on metallic products by mechanical deposition. The coating is provided in four thickness classes (see Table 1) and several finish types (see Table 2).
1.2Toxicity—Warning: Cadmium is toxic; therefore these coatings should not be used on articles that will contact food or beverages, or for dental and other equipment that may be inserted into the mouth. Also, the coatings should not be used on articles that will be heated to high temperatures, because cadmium will form toxic fumes. Similarly, if coated articles are welded, soldered, or otherwise heated during fabrication, adequate ventilation should be provided to exhaust toxic fumes.
1.3Similar Documents—Other kinds of mechanically deposited coatings are covered by Specifications B635, B695, and B696.
1.4The following precautionary caveat pertains only to the test method portion, Section 9, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM F 1470 : 2012 | Standard Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection |
| ASTM F 1470 : 2002 | Standard Guide for Fastener Sampling for Specified Mechanical Properties and Performance Inspection |
| ASTM F 1470 : 2009 | Standard Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection |
| ASTM E 27 : 1964 : R1981 | Method for Spectrographic Analysis of Zinc and Zinc Alloys by the Solution-Residue Technique (Withdrawn 1986) |
| ASTM E 536 : 2016 : REDLINE | Standard Test Methods for Chemical Analysis of Zinc and Zinc Alloys |
| ASTM F 1470 : 2018 | Standard Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection |
| ASTM F 1470 : 2001 | Standard Guide for Fastener Sampling for Specified Mechanical Properties and Performance Inspection |
| ASTM F 1470 : 2019 | Standard Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection |
| ASTM B 320 : 1960 : R2019 | Standard Practice for Preparation of Iron Castings for Electroplating |
| ASTM B 183 : 2018 | Standard Practice for Preparation of Low-Carbon Steel for Electroplating |
| ASTM E 396 : 2004 | Standard Test Methods for Chemical Analysis of Cadmium |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.