ASTM B 369 : 2009 : R2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Copper-Nickel Alloy Castings
Hardcopy , PDF
09-08-2024
English
01-04-2016
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 02.01, 2017 Specifies the requirements for copper-nickel alloy castings with nominal compositions.
| Committee |
B 05
|
| DevelopmentNote |
Supersedes QQ C 390 (B) & MIL C 20159 (07/2004)
|
| DocumentType |
Standard
|
| Pages |
5
|
| ProductNote |
Reconfirmed 2016
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This specification establishes the requirements for copper-nickel alloy castings with nominal compositions shown in Table 1. These are as follows:2
| Copper Alloy UNS No.2 | Previous Designation |
| C96200 | Alloy A |
| C96400 | Alloy B |
1.2Castings of these alloys are used primarily for corrosion-resistance applications such as in construction and for pressure vessels, particularly in marine pumps, valves, and fittings.
1.3These alloys are considered weldable, but they may be ordered with a weld test to ensure weldability. When extensive welding is to be performed on the casting, weldability tests should be specified in the ordering information (5.2.6) to ensure proper welding characteristics.
1.4Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5The following hazard statement applies only to Section 8, Weldability Test, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM B 208 : 2014 : REDLINE | Standard Practice for Preparing Tension Test Specimens for Copper Alloy Sand, Permanent Mold, Centrifugal, and Continuous Castings |
| ASTM E 527 : 2016 : REDLINE | Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS) |
| ASTM B 824 : 2017 : REDLINE | Standard Specification for General Requirements for Copper Alloy Castings |
| AWS A5.6 : 84(R2000) | COVERED COPPER AND COPPER ALLOY ARC WELDING ELECTRODES, SPECIFICATION FOR |
| ASTM B 846 : 2011-07 | TERMINOLOGY FOR COPPER AND COPPER ALLOYS |
| ASME PV CODE SET : 2017 | BOILER AND PRESSURE VESSEL CODE - COMPLETE SET |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.