ASTM A 600 : 1992 : REV A : R2010
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Tool Steel High Speed
Hardcopy , PDF
17-03-2024
English
01-10-2010
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 01.05, 2017 Describes tungsten and molybdenum-type high-speed steels available as annealed, hot-rolled forgings, bars, plate, strip or sheet and annealed, cold-finished forgings or bars used in the making of tools.
| Committee |
A 01
|
| DevelopmentNote |
Supersedes QQ T 590 (07/2004)
|
| DocumentType |
Standard
|
| Pages |
13
|
| ProductNote |
Reconfirmed 2010
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This specification covers tungsten-type and molybdenum-type high-speed steels available as annealed, hot-rolled bars, forgings, plate, sheet, or strip, and annealed, cold-finished bars or forgings used primarily in the fabrication of tools.
1.2 Seven types of tungsten high-speed tool steels designated T1, T2, etc., seventeen types of molybdenum high-speed tool steels designated M1, M2, etc., and two intermediate high speed steels designated as M50 and M52 are covered. Selection will depend upon design, service conditions, and mechanical properties.
1.3 The term “high-speed steel” is described and its minimum requirements are covered in the Annex.
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
| ASTM E 30 : 1989 | Test Methods for Chemical Analysis of Steel, Cast Iron, Open-Hearth Iron, and Wrought Iron (Withdrawn 1995) |
| FED-STD-123 Revision H:2007 | MARKING FOR SHIPMENT (CIVIL AGENCIES) |
| ASTM A 700 : 2014 | Standard Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment |
| MIL-STD-163 Revision C:1978 | STEEL MILL PRODUCTS PREPARATION FOR SHIPMENT AND STORAGE |
| FED-STD-183 Revision C:1980 | CONTINUOUS IDENTIFICATION MARKING OF IRON AND STEEL PRODUCTS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.