Customer Support: 131 242

  • There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

ANSI INCITS 293 : 1996 : R2006

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

INFORMATION TECHNOLOGY - SERIAL STORAGE ARCHITECTURE PHYSICAL LAYER 1 (SSA-PH1)

Available format(s)

Hardcopy , PDF

Superseded date

23-04-2024

Language(s)

English

Published date

01-01-2006

$98.22
Including GST where applicable

Foreword
Introduction
1 Scope
  1.1 SSA-PH1 characteristics
  1.2 SSA family of standards
2 Normative references
3 Definitions, symbols, and abbreviations
  3.1 Definitions
  3.2 Symbols and abbreviations
4 Conventions
5 Modulation
6 Data rate
7 Electrical requirements
  7.1 Line driver
  7.2 Line receiver
  7.3 Line segment termination
  7.4 Ground shift
  7.5 Port connection
  7.6 System level noise margin
8 Interconnections
  8.1 Internal connectors
  8.2 Internal port connections
  8.3 Internal options bay connections
  8.4 Internal device power connections
  8.5 External connections
Annexes
A Transfer impedance testing procedure
B Internal connector testing procedure
C External connector testing procedure
D Line fault detection scheme examples
E Circuit for degrading signal amplitude and introducing common
   mode levels
F Preferred test configurations for SSA links
G Implementation guidelines
H Reference for copper, polymer dielectric, non-equalized SSA
   cable assemblies

Specifies the physical layer of the Serial Storage Architecture (SSA).

Committee
X3T10
DocumentType
Standard
Pages
95
ProductNote
Reconfirmed 2006
PublisherName
Information Technology Industry Council
Status
Superseded
SupersededBy
Supersedes

IEC 60512-6:1984 Electromechanical components for electronic equipment; basic testing procedures and measuring methods. Part 6: Climatic tests and soldering tests
IEC 60512-7:1993 Electromechanical components for electronic equipment; basic testing procedures and measuring methods - Part 7: Mechanical operating tests and sealing tests
IEC 60512-11-7:2003 Connectors for electronic equipment - Tests and measurements - Part 11-7: Climatic tests - Test 11g: Flowing mixed gas corrosion test
IEC 60512-4:1976 Electromechanical components for electronic equipment; basic testing procedures and measuring methods. Part 4: Dynamic stress tests
IEC 60512-5:1992 Electromechanical components for electronic equipment; basic testing procedures and measuring methods - Part 5: Impact tests (free components), static load tests (fixed components), endurance tests and overload tests

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.

Need help?
Call us on 131 242, then click here to start a Screen Sharing session
so we can help right away! Learn more