AGMA 2116 : A
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
EVALUATION OF DOUBLE FLANK TESTERS FOR RADIAL COMPOSITE MEASUREMENT OF GEARS
Hardcopy
11-06-2024
English
29-12-2005
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
1 Scope
2 Normative references
3 Definition of terms
4 Application
5 Condition of the measurement system
6 Environment
7 Artifacts
8 Measurement uncertainty
Annexes
A Method for estimating uncertainty
B Calibration certificate requirements
Defines evaluation methods for double flank test used for radial composite measurement of gears. used for radial composite measurement of gears.
| DevelopmentNote |
Supplement is available separately, see record AGMA 935. (02/2015)
|
| DocumentType |
Standard
|
| ISBN |
1-55589-871-8
|
| Pages |
9
|
| PublisherName |
American Gear Manufacturers Association
|
| Status |
Superseded
|
| SupersededBy |
| AGMA 935 : A | RECOMMENDATIONS RELATIVE TO THE EVALUATION OF RADIAL COMPOSITE GEAR DOUBLE FLANK TESTERS |
| AGMA 915-2 : A | INSPECTION PRACTICES - PART 2: CYLINDRICAL GEARS - RADIAL MEASUREMENTS |
| AGMA 2015-1 : A | ACCURACY CLASSIFICATION SYSTEM - TANGENTIAL MEASUREMENTS FOR CYLINDRICAL GEARS |
| ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| ISO/TS 14253-2:1999 | Geometrical Product Specifications (GPS) Inspection by measurement of workpieces and measuring equipment Part 2: Guide to the estimation of uncertainty in GPS measurement, in calibration of measuring equipment and in product verification |
| ISO 18653:2003 | Gears Evaluation of instruments for the measurement of individual gears |
| AGMA 935 : A | RECOMMENDATIONS RELATIVE TO THE EVALUATION OF RADIAL COMPOSITE GEAR DOUBLE FLANK TESTERS |
| AGMA 2015-2 : A | GEAR TOOTH FLANK TOLERANCE CLASSIFICATION SYSTEM - DEFINITIONS AND ALLOWABLE VALUES OF DOUBLE FLANK RADIAL COMPOSITE DEVIATIONS |
| AGMA 915-3 : A1999(R2017) | INSPECTION PRACTICES - GEAR BLANKS, SHAFT CENTER DISTANCE AND PARALLELISM |
| AGMA 1012 : 2005 | GEAR NOMENCLATURE, DEFINITIONS OF TERMS WITH SYMBOLS |
| ISO/TR 10064-5:2005 | Code of inspection practice Part 5: Recommendations relative to evaluation of gear measuring instruments |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.