09/30208678 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
BS 7291-3 - THERMOPLASTICS PIPES AND ASSOCIATED FITTINGS FOR HOT AND COLD WATER FOR DOMESTIC PURPOSES AND HEATING INSTALLATIONS IN BUILDINGS - PART 3: SPECIFICATION FOR CROSS-LINKED POLYETHYLENE (PE-X) PIPES AND ASSOCIATED FITTINGS
Hardcopy , PDF
30-04-2010
English
Foreword
1 Scope
2 Normative references
3 Materials
4 PE-X pipes
5 Fittings for PE-X pipes
6 Marking and associated information
Annexes
Annex A (normative) - Method of test for the degree of
cross-linking
Annex B (normative) - Method of test for resistance to
pull-out of assembled joints
Annex C (informative) - Guidance on factory quality
control procedures
Bibliography
| Committee |
PRI/88
|
| DocumentType |
Draft
|
| Pages |
18
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| BS EN ISO 6259-1:2015 | Thermoplastics pipes. Determination of tensile properties General test method |
| BS 5214-2:1978 | Specification for testing machines for rubbers and plastics Constant rate of force application machines |
| BS EN ISO 3126:2005 | Plastics piping systems. Plastics components. Determination of dimensions |
| BS EN 681-1:1996 | Elastomeric seals. Material requirements for pipe joint seals used in water and drainage applications Vulcanized rubber |
| BS EN ISO 15875-1:2003 | Plastics piping systems for hot and cold water installations. Crosslinked polyethylene (PE-X) General |
| BS EN 1057 : 2006 | COPPER AND COPPER ALLOYS - SEAMLESS, ROUND COPPER TUBES FOR WATER AND GAS IN SANITARY AND HEATING APPLICATIONS |
| BS ISO 4065:1996 | Thermoplastics pipes. Universal wall thickness table |
| BS EN 921:1995 | Plastics piping systems. Thermoplastics pipes. Determination of resistance to internal pressure at constant temperature |
| BS EN ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| BS EN 1254-2:1998 | Copper and copper alloys. Plumbing fittings Fittings with compression ends for use with copper tubes |
| BS EN ISO 15876-1:2017 | Plastics piping systems for hot and cold water installations. Polybutene (PB) General |
| BS EN 1254-3:1998 | Copper and copper alloys. Plumbing fittings Fittings with compression ends for use with plastics pipes |
| ISO 6259-3:2015 | Thermoplastics pipes Determination of tensile properties Part 3: Polyolefin pipes |
| BS EN ISO 1043-1:2011 | PLASTICS - SYMBOLS AND ABBREVIATED TERMS - PART 1: BASIC POLYMERS AND THEIR SPECIAL CHARACTERISTICS (ISO 1043-1:2011) |
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Logging out.