I.S. EN 12445:2000

1 Scope
2 Normative references
3 Terms and definitions
4 Test method
  4.1 General
      4.1.1 Avoiding or safeguarding against
             crushing, shearing and drawing-in
             points
      4.1.2 Safeguarding against hazard or being
             lifted
      4.1.3 Safeguarding against impact hazards
  4.2 Drive unit and power supply
      4.2.1 Electrical drive unit
      4.2.2 Electrical equipment
      4.2.3 Additional requirements for hydraulic
             drive systems
      4.2.4 Additional requirements for pneumatic
             drive systems
      4.2.5 Controls
      4.2.6 Switching on of the drive
      4.2.7 Switching off of the drive
      4.2.8 Manual actuators
      4.2.9 Supply disconnecting device
      4.2.10 EMC
  4.3 Manual operation
  4.4 Additional hazards
      4.4.1 Pass doors
      4.4.2 Trapping
      4.4.3 Leaf travel limiting devices
      4.4.4 Unintended movements of the door leaf
      4.4.5 Interlocking
5 Force measuring method
  5.1 Measuring equipment
      5.1.1 Reference measuring equipment
      5.1.2 Measuring equipment for 'in situ'
             tests
  5.2 Points of measuring
      5.2.1 Sliding door
      5.2.2 Hinged swing door
      5.2.3 Folding door
      5.2.4 Vertically moving doors
      5.2.5 Barriers
6 Single fault failure
  6.1 Force limiting devices
  6.2 Other safeguarding devices
7 Testing method for presence detection
  7.1 Test pieces
  7.2 Testing of presence detection equipment to be
      used in conjunction with force limitation
      7.2.1 Testing of horizontal sliding and any
             type of vertically moving doors
      7.2.2 Testing of hinged and folding doors
      7.2.3 Testing of barriers
  7.3 Testing of presence detection system to be used
      without force limitation
      7.3.1 Testing of presence detection
             installed on the door leaf
      7.3.2 Testing of presence detection not
             installed on the door leaf
  7.4 Testing of presence detection in case of risk
      of being lifted
8 Test report

Defines the test methods to be applied to a power operated door to demonstrate compliance with the requirements specified in EN 12453:2000.