EN ISO 22442-3:2007
Current
The latest, up-to-date edition.
Medical devices utilizing animal tissues and their derivatives - Part 3: Validation of the elimination and/or inactivation of viruses and transmissible spongiform encephalopathy (TSE) agents (ISO 22442-3:2007)
12-15-2007
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
4.1 Risk management
4.2 Sourcing and manufacturing process
4.3 General requirements related to validation
5 Literature review
5.1 Conduct of the literature review
5.2 Application of literature review output
5.3 Viruses
5.4 TSE agents
6 Elimination and/or inactivation study of viruses and TSE
agents
6.1 General
6.2 Protocol
6.3 Conduct of the study
6.4 Interpretation of data
7 Final report
8 Review of final report
9 Routine monitoring and control of critical process parameters
Annex A (normative) Requirements related to literature review
Annex B (informative) Guidance on the elimination and/or
inactivation study for viruses
Annex C (informative) Guidance on the elimination and/or
inactivation study for TSE agents
Annex D (informative) Guidance on scaling down
Annex E (informative) Statistical evaluation of virus titres
and reduction factors and assessment of
their validity
Annex F (informative) Calculation of reduction factors
Annex G (informative) Probability of detection of agents at
low concentrations
Annex ZA (informative) Relationship between this European
Standard and the Essential Requirements
of Directive 93/42/EEC as amended by
Commission Directive 2003/32/EC
Bibliography
ISO 22442-3:2007 specifies requirements for the validation of the elimination and/or inactivation of viruses and TSE agents during the manufacture of medical devices (excluding in vitro diagnostic medical devices) utilizing animal tissue or products derived from animal tissue, which are non-viable or have been rendered non-viable. It applies where required by the risk management process as described in ISO 22442-1. It does not cover other transmissible and non-transmissible agents.
Committee |
CEN/TC 206
|
DevelopmentNote |
Supersedes EN 12442-3. (02/2008)
|
DocumentType |
Standard
|
PublisherName |
Comite Europeen de Normalisation
|
Status |
Current
|
Supersedes |
Standards | Relationship |
SS-EN ISO 22442-3 :2007 | Identical |
ISO 22442-3:2007 | Identical |
UNI EN ISO 22442-3 : 2008 | Identical |
DIN EN ISO 22442-3:2008-03 | Identical |
SN EN ISO 22442-3:2008 | Identical |
NS EN ISO 22442-3 : 1ED 2007 | Identical |
NBN EN ISO 22442-3 : 2008 | Identical |
NEN EN ISO 22442-3 : 2008 | Identical |
NF EN ISO 22442-3 : 2008 | Identical |
PN EN ISO 22442-3 : 2008 | Identical |
UNE-EN ISO 22442-3:2008 | Identical |
BS EN ISO 22442-3:2007 | Identical |
I.S. EN ISO 22442-3:2007 | Identical |
DIN EN ISO 22442-1:2016-05 | Medical devices utilizing animal tissues and their derivatives - Part 1: Application of risk management (ISO 22442-1:2015) |
I.S. EN ISO 15798:2013 | OPHTHALMIC IMPLANTS - OPHTHALMIC VISCOSURGICAL DEVICES (ISO 15798:2013) |
BS EN ISO 22442-1:2015 | Medical devices utilizing animal tissues and their derivatives Application of risk management |
I.S. EN ISO 22442-1:2015 | MEDICAL DEVICES UTILIZING ANIMAL TISSUES AND THEIR DERIVATIVES - PART 1: APPLICATION OF RISK MANAGEMENT (ISO 22442-1:2015) |
EN ISO 22442-1:2015 | Medical devices utilizing animal tissues and their derivatives - Part 1: Application of risk management (ISO 22442-1:2015) |
ISO 22442-1:2015 | Medical devices utilizing animal tissues and their derivatives Part 1: Application of risk management |
ISO 13408-4:2005 | Aseptic processing of health care products — Part 4: Clean-in-place technologies |
ISO 14160:2011 | Sterilization of health care products Liquid chemical sterilizing agents for single-use medical devices utilizing animal tissues and their derivatives Requirements for characterization, development, validation and routine control of a sterilization process for medical devices |
ISO 14155-2:2003 | Clinical investigation of medical devices for human subjects Part 2: Clinical investigation plans |
ISO 11135:2014 | Sterilization of health-care products — Ethylene oxide — Requirements for the development, validation and routine control of a sterilization process for medical devices |
ISO 13408-2:2003 | Aseptic processing of health care products Part 2: Filtration |
ISO 11737-1:2006 | Sterilization of medical devices Microbiological methods Part 1: Determination of a population of microorganisms on products |
ISO 13485:2016 | Medical devices Quality management systems Requirements for regulatory purposes |
ISO 14937:2009 | Sterilization of health care products General requirements for characterization of a sterilizing agent and the development, validation and routine control of a sterilization process for medical devices |
ISO 14155-1:2003 | Clinical investigation of medical devices for human subjects Part 1: General requirements |
ISO 22442-1:2015 | Medical devices utilizing animal tissues and their derivatives Part 1: Application of risk management |
ISO 13408-3:2006 | Aseptic processing of health care products Part 3: Lyophilization |
ISO 13408-1:2008 | Aseptic processing of health care products — Part 1: General requirements |
ISO/TS 11139:2006 | Sterilization of health care products Vocabulary |
ISO 22442-2:2015 | Medical devices utilizing animal tissues and their derivatives Part 2: Controls on sourcing, collection and handling |
ISO 13408-6:2005 | Aseptic processing of health care products Part 6: Isolator systems |
ISO 17665-1:2006 | Sterilization of health care products — Moist heat — Part 1: Requirements for the development, validation and routine control of a sterilization process for medical devices |
ISO 13408-5:2006 | Aseptic processing of health care products Part 5: Sterilization in place |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.