BS EN 10307:2001

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Items for agreements
5 Principle
6 Procedure
7 Personnel qualification
8 Ultrasonic test equipment
   8.1 Instrument
   8.2 Probe
   8.3 Calibration blocks
   8.4 Reference blocks
   8.5 Couplant
9 Routine calibration and checking
10 Stage of manufacture
11 Surface condition
12 Sensitivity setting
13 Scanning
   13.1 General
   13.2 Scanning speed
   13.3 Testing of the flat product body
   13.4 Testing of the flat product edges
14 Evaluation of discontinuities
   14.1 Testing the flat product body
   14.2 Testing the edges
15 Recording level and acceptance criteria
16 Test report
Annex A (informative) List of equivalent terms in
         several European languages
Bibliography

Specifies a method for the ultrasonic-testing of uncoated flat austenitic and austenitic-ferritic stainless steel product for internal discontinuities. Also applies to flat product in nominal thickness range of 6 mm to 200 mm.

This European Standard describes a method for the ultrasonic-testing of uncoated flat austenitic and austenitic-ferritic stainless steel product for internal discontinuities. It is applicable to flat product in nominal thickness range of 6 mm to 200 mm. Mechanised, semi-automatic or automatic techniques may be used but should be agreed between the purchaser and the supplier. This standard also defines 3 quality classes for the flat product body (classes S1, S2 and S3) and 4 quality classes (E1, E2, E3, E4) for the edges in accordance with the criteria specified in clause 12. Other methods of testing, e.g. by transmission technique or other test equipments may be used at the manufacturer\'s discretion provided that they give equivalent results to those obtained under the conditions of this standard. In the event of a dispute, only the method defined in this standard prevails. Testing of flat product of thickness less than 6 mm may be the subject of special agreements between the parties concerned.