BS 6582:2000

Committees responsible
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Designation
5 Information to be supplied by the purchaser
6 General requirements
7 Specific requirements
Annex A (normative) Methods for determination of coating
                    mass
Annex B (informative) Proposed text for contractual clauses
Table 1 - Characteristics
Table 2 - Coating mass

Defines the criteria for continuously hot-dip lead alloy (terne) coated cold reduced low carbon steel flat products in forming and drawing grades. Applicable to flat products between 0.4mm and 2.0mm thickness, and widths not exceeding 1 350mm, in sheet and strip.

This British Standard specifies requirements for continuously hot-dip lead alloy (terne) coated cold reduced low carbon steel flat products in drawing and forming grades.

This standard applies to flat products from over 0.4 mm up to and including 2.0 mm thick and widths up to 1 350 mm, in strip and sheet. It applies to products with terne coatings having a nominal mass of 120 g/m² and to commercial grade terne coating (CGT) having no specified coating mass but meeting the other requirements of this standard.

NOTE The products in this standard can be used for applications where suitability for soldering and cold forming are required and corrosion resistance is a principal factor. The coating mass specified and the thickness of the base material should be compatible with the desired service life and forming requirements.