MIL-F-3541 Revision C:1989
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Fittings, Lubrication, General Specification for (S/S by SAE-AS35411)
28-02-1989
12-07-2002
Gives threaded fittings used for admitting and retaining lubricants supplied by pressure lubricating equipment.
| DevelopmentNote |
C Notice 2 - Notice of Cancellation/Superseded by SAE AS 35411 (09/2002)
|
| DocumentType |
Standard
|
| Pages |
22
|
| PublisherName |
US Military Specs/Standards/Handbooks
|
| Status |
Superseded
|
This specification covers threaded lubrication fittings to be used for admitting and retaining lubricants supplied by pressure lubricating equipment.
| MIL-B-12582 Revision C:1984 | Block, Tackle, Haul Back, for Wire Rope (S/S by A-A-59390) |
| MIL-A-26846 Revision B:1984 | Air Conditioner, A/M32C-4, Trailer Mounted, Vapor Cycle, Electric, Motor Driven (No S/S Document) |
| MIL-F-8839 Revision A:1988 | Fittings, Lubrication, Drive Type (No S/S Document) |
| MIL-A-52940 Revision C:1987 | Aerosol Generator, Non Thermal, Insecticide, Ultra Low Volume (No S/S Document) |
| MIL-STD-838 Revision C:1983 | LUBRICATION OF MILITARY EQUIPMENT |
| MIL-C-87972 Revision A:1987 | Casters, Rigid and Swivel, General Specification for |
| MIL-W-19882 Revision A:1960 | WINCHES, DRUM, POWER OPERATED, BATHYTHERMOGRAPH (NO S/S DOCUMENT) |
| DEFSTAN 00-970(PT0)/9(2012) : 2012 | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 0: PROCEDURES FOR USE, CONTENT AND DEFINITIONS |
| MIL-B-23170 Revision A:1978 | Boiler, Steam, High Pressure Water Tube, Packaged Type,(5,000 to 50,000 Pounds Per Hour Fired by Coal, Gas or Combination Oil/Gas) (S/S by MIL-B-17095) |
| MIL-C-4751 Revision D:1983 | Casters, Rigid and Swivel, Precision Heavy Duty, and Shock Absorbing (S/S by NASM4751) |
| MIL-P-52327 Revision C:1990 | Pumps, Centrifugal, Electric-Motor-Driven, Positive Prime, Petroleum Products, Airfield Defueling and Receiving (No S/S Document) |
| MIL-C-13874 Revision K:1992 | Compressors, Reciprocating and Rotary, Air, Electric Motor Driven |
| DEFSTAN 00-970(PT0)/14(2014) : 2014 | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 0: PROCEDURES FOR USE, CONTENT AND DEFINITIONS |
| DEFSTAN 00-970(PT0)/7(2011) : 2011 | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 0: PROCEDURES FOR USE, CONTENT AND DEFINITIONS |
| DEFSTAN 00-970(PT0)/12(2014) : 2014 | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 0: PROCEDURES FOR USE, CONTENT AND DEFINITIONS |
| DEFSTAN 00-970(PT0)/13(2014) : 2014 | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 0: PROCEDURES FOR USE, CONTENT AND DEFINITIONS |
| DEFSTAN 00-970(PT0)/11(2013) : 2013 | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 0: PROCEDURES FOR USE, CONTENT AND DEFINITIONS |
| DEFSTAN 00-970(PT0)/8(2011) : 2011 | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 0: PROCEDURES FOR USE, CONTENT AND DEFINITIONS |
| MIL F 9490 : D | FLIGHT CONTROL SYSTEMS - DESIGN, INSTALLATION AND TEST OF PILOTED AIRCRAFT, GENERAL SPECIFICATION FOR |
| DEFSTAN 00-970(PT0)/10(2013) : 2013 | DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 0: PROCEDURES FOR USE, CONTENT AND DEFINITIONS |
| MIL-C-0052980 Revision C:1994 | Compressors, Reciprocating and Rotary, Air Diesel-Engine-Driven, or Gasoline-Engine-Driven (No S/S Document) |
| MIL-E-4158 Revision E:1973 | Electronic Equipment, Ground, General Requirements for (S/S by MIL-STD-454) |
| MIL-C-13962 Revision B:1966 | Crushing, Screening, and Washing Plant, Diesel-Engine and Electric-Motor Driven, 225-Tons Per Hour (No S/S Document) |
| MIL-C-13899 Revision F:1985 | Compressor Unit, Rotary, Air Wheelbarrow Frame Mounted, Two Pneumatic Tires, Gasoline Engine Driven, 60 CFM, 6.5 PSIG |
| MIL-T-17523 Revision D:1976 | Turbine, Steam, Auxiliary (and Reduction Gear) Mechanical Drive |
| MIL-A-26624 Revision B:1981 | Air Conditioner, A/M32C-5, Trailer Mounted, Vapor Cycle, Electric Motor Driven (No S/S Document) |
| MIL-P-10360 Revision G:1993 | Pump, Centrifugal, 4 Inch and 6 Inch, Gasoline Engine and Diesel Engine Driven, for Water (No S/S Document) |
| MIL-E-17814 Revision F:1992 | Expansion Joints, Pipe, Slip-Type, Packed (No S/S Document) |
| MIL-S-8512 Revision D:1974 | Support Equipment, Aeronautical, Special, General Specification for the Design of |
| MIL-T-21578 Revision A:1966 | TEST EQUIPMENT, HAZARDOUS LOCATION, INSTALLED, BASIC REQUIREMENTS FOR |
| MIL-C-52037 Revision F:1990 | Compressor Unit, Reciprocating, Power-Driven, Air, 15 CFM, 3,500-PSI |
| SAE AS8090A | Mobility, Towed Aerospace Ground Equipment, General Requirements For |
| MIL-T-9720 Revision F:1984 | Truck, Lift, Aerial Stores, 3000 Pounds Capacity MJ-1A and MJ-1B |
| MIL-V-24439 Revision A:1984 | VALVE, OXYGEN, HELIUM AND HELIUM OXYGEN MIXTURE, HIGH PRESSURE FOR GAS SERVICES |
| MIL E 17807 : C | ELEVATOR, WEAPON AND CARGO, ELECTROMECHANICAL (SHIPBOARD) |
| MIL-HDBK-838 Base Document:1997 | Lubrication of Military Equipment |
| MIL-C-13522 Revision C:1966 | CRUSHER, JAW, ROCK, AIRBORNE, 15-TPH CAPACITY |
| MIL-C-7474 Revision E:1978 | Caster, Industrial (No S/S Document) |
| MIL-B-17397 Revision D:1983 | Bitts, Cleats, and Chocks (No S/S Document) |
| MIL-B-10122 Revision E:1991 | Barge, Liquid Cargo: Nonpropelled, Steel, Offshore, 4, 160-Barrel, 120-Foot, Design 231C (No S/S Document) |
| MIL M 8090 : F | MOBILITY, TOWED AEROSPACE GROUND EQUIPMENT, GENERAL REQUIREMENTS FOR |
| GGG-L-795 Revision E:1990 | LUBRICATING UNIT, POWER OPERATED, AND PUMPING UNITS, PRESSURE LUBRICATING, DRUM MOUNTING |
| MIL V 18110 : F | VALVE, GATE, CAST OR FORGED STEEL, AND ALLOY STEEL, OUTSIDE SCREW AND YOKE (SIZES 2-1/2 INCHES AND LARGER) |
| DOD-HDBK-791 Base Document:1988 | Maintainability Design Techniques Metric |
| MIL-S-12511 Revision G:1983 | Sprayer, Pesticide, Frame-Mounted: Gasoline-Engine-Driven, Mist and Solid Stream, 360 GHP (No S/S Document) |
| GGG-B-485 Revision B:1978 | Block, Tackle, Wire Rope, with Swivel Hook, (for Crane Use) (No S/S Document) |
| MIL-P-11268 Revision L:1983 | PARTS, MATERIALS, AND PROCESSES USED IN ELECTRONIC EQUIPMENT (NO S/S DOCUMENT) |
| MIL-DTL-81944 Revision C:1997 | Trailer, Munitions, Small (MHU-126 A/M) |
| MIL-W-5013 Revision L:1991 | Wheel and Brake Assemblies, Aircraft General Specification For |
| MIL-C-18244 Revision A:1962 | Control and Stabilization Systems: Automatic, Piloted Aircraft, General Specification for |
| MIL-STD-129 Revision R:2014 | Military Marking for Shipment and Storage |
| MIL-STD-970 Base Document:1987 | STANDARDS AND SPECIFICATIONS, ORDER OF PREFERENCE FOR THE SELECTION OF (NO S/S DOCUMENT) |
| PPP-B-665 Revision D:1972 | Boxes, Paperboard, Metal Edged and Components (S/S by A-A-669and A-A-2807) |
| PPP-B-636 Revision J:1981 | Boxes, Shipping, Fiberboard (S/S by ASTM-D1974 and ASTM-D5118) |
| PPP-B-566 Revision E:1974 | Boxes, Folding, Paperboard |
| ASME B46.1 : 2009 | SURFACE TEXTURE (SURFACE ROUGHNESS, WAVINESS, AND LAY) |
| PPP-T-60 Revision E:1986 | Tape: Packaging, Waterproof (S/S by ASTM D5486/ASTM-D5486M) |
| PPP-B-676 Revision E:1992 | Boxes, Setup |
| VV-G-632 Revision B:1989 | Grease, Industrial, General Purpose (S/S by MIL-PRF-10924) |
| QQ-S-763 Revision F:1996 | STEEL BARS, WIRE, SHAPES, AND FORGINGS; CORROSION RESISTANT (S/S BY SAE-AMS-QQ-S-763) |
| QQ-W-390 Revision C:1970 | WIRE, NICKEL-CHROMIUM-IRON ALLOY (S/S BY ASTM-B166) |
| MIL G 10924 : F | GREASE, AUTOMOTIVE AND ARTILLERY |
| MIL-P-116 Revision J:1988 | PRESERVATION, METHODS OF (S/S BY MIL-STD-2073-1) |
| MIL G 23827 : B | GREASE, AIRCRAFT AND INSTRUMENT, GEAR AND ACTUATOR SCREW |
| QQ-P-416 Revision F:1991 | Plating, Cadmium (Electrodeposited) (S/Sby SAE-AMS-QQ-P-416) |
| FED-STD-H28 Revision A:1994 | Screw-Thread Standards for Federal Services |
| MIL-STD-105 Revision E:1989 | Sampling Procedures and Tables for Inspection by Attributes (See Notice 3 for Replacement Information) |
| PPP-B-640 Revision D:1966 | Boxes, Fiberboard, Corrugated, Triple Wall (S/S by ASTM-D5168) |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.