AGMA 6123 : REV A : 2006
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
DESIGN MANUAL FOR ENCLOSED EPICYCLIC GEAR DRIVES
01-01-2000
15-06-2022
Applicable to enclosed epicyclic speed reducers and increasers which use spur and helical gears and Applicable to non-aircraft, industrial, vehicular, or machine tool gear units with carrier speeds less than 1800 rpm and pinion absolute speed less than 4500 rpm.
| DevelopmentNote |
Supersedes AGMA 6023. (10/2006)
|
| DocumentType |
Standard
|
| ProductNote |
Reconfirmed 2006
|
| PublisherName |
American Gear Manufacturers Association
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| ISO/TR 13593:1999 | Enclosed gear drives for industrial applications |
| ISO 6336-2:2006 | Calculation of load capacity of spur and helical gears — Part 2: Calculation of surface durability (pitting) |
| AGMA 2101 : D | FUNDAMENTAL RATING FACTORS AND CALCULATION METHODS FOR INVOLUTE SPUR AND HELICAL GEAR TEETH (METRIC EDITION) |
| AGMA ISO 1328 1 : B2014 | CYLINDRICAL GEARS - ISO SYSTEM OF FLANK TOLERANCE CLASSIFICATION - PART 1: DEFINITIONS AND ALLOWABLE VALUES OF DEVIATIONS RELEVANT TO FLANKS OF GEAR TEETH |
| ISO 9085:2002 | Calculation of load capacity of spur and helical gears — Application for industrial gears |
| ISO 6336-3:2006 | Calculation of load capacity of spur and helical gears — Part 3: Calculation of tooth bending strength |
| AGMA 6001 : D | DESIGN AND SELECTION OF COMPONENTS FOR ENCLOSED GEAR DRIVES |
| ISO 281:2007 | Rolling bearings — Dynamic load ratings and rating life |
| AGMA ISO 6336-6 : A2008(R2014) | CALCULATION OF LOAD CAPACITY OF SPUR AND HELICAL GEARS - PART 6: CALCULATION OF SERVICE LIFE UNDER VARIABLE LOAD |
| ISO 6336-5:2016 | Calculation of load capacity of spur and helical gears — Part 5: Strength and quality of materials |
| AGMA 925 : A | EFFECT OF LUBRICATION ON GEAR SURFACE DISTRESS |
| AGMA 9005 : E | INDUSTRIAL GEAR LUBRICATION |
| ISO 6336-1:2006 | Calculation of load capacity of spur and helical gears — Part 1: Basic principles, introduction and general influence factors |
| AGMA 927 : A | LOAD DISTRIBUTION FACTORS - ANALYTICAL METHODS FOR CYLINDRICAL GEARS |
| AGMA/AWEA 6006 : A2003(R2016) | STANDARD FOR DESIGN AND SPECIFICATION OF GEARBOXES FOR WIND TURBINES |
| AGMA 6113 : A | INDUSTRIAL ENCLOSED GEAR DRIVES (METRIC EDITION) |
| AGMA 1012 : 2005 | GEAR NOMENCLATURE, DEFINITIONS OF TERMS WITH SYMBOLS |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.