NEN EN 639 : 1994

Committees responsible
National foreword
Foreword
Introduction
1. Scope
2. Normative references
3. Definitions
4. General
    4.1 Concrete pipe behaviour
    4.2 Plans and data to be supplied by purchaser
         4.2.1 Design data
         4.2.2 Specification and drawings
         4.2.3 Design responsibility
    4.3 Data to be submitted by the manufacturer
         4.3.1 Parameters for surge calculation
         4.3.2 Detail drawings and schedules
         4.3.3 Tabulated layout schedule
    4.4 Design requirements
5. Materials
    5.1 Cement
    5.2 Aggregates
    5.3 Mixing water
    5.4 Admixtures and additives
    5.5 Steel for cylinders, fittings and specials
    5.6 Steel for joint rings
    5.7 Reinforcing steel
    5.8 Sealing rings
    5.9 Chloride content
6. Common requirements for products
    6.1 Geometry and dimensions
         6.1.1 Nominal sizes
         6.1.2 Internal diameters
         6.1.3 Lengths
         6.1.4 Straightness and surface evenness
         6.1.5 Squareness
         6.1.6 Wall thickness
         6.1.7 Joints
         6.1.8 Structure of steel joint with an elastomeric
                sealing ring
         6.1.9 Structure of a site welded joint
         6.1.10 Elastomeric sealing rings
         6.1.11 Steel cylinder
    6.2 Curing
    6.3 Rework during manufacturing process (repairs)
    6.4 Test methods
         6.4.1 Internal diameter
         6.4.2 Internal barrel length
         6.4.3 Straightness and surface evenness
         6.4.4 Squareness
         6.4.5 Wall thickness
         6.4.6 Steel joint rings
         6.4.7 Hydrostatic testing of steel cylinder for pipe
         6.4.8 Liquid penetrant test
         6.4.9 Sealing rings (elastomeric gaskets)
         6.4.10 Concrete strength
         6.4.11 Concrete crack
         6.4.12 Deflection and shear test
    6.5 Fittings and specials
         6.5.1 General
         6.5.2 Materials
         6.5.3 Fabrication
         6.5.4 Design of fittings and specials
7. Quality control
    7.1 General
    7.2 Receiving inspection
    7.3 Testing rates
    7.4 Records
    7.5 Access to manufacturer's facilities
    7.6 Responsibility
    7.7 Product construction directive
8. Marking
9. Interconnection for products
10. Installation and testing
    10.1 Installation
    10.2 Preparation for testing
    10.3 Site test
Annex A (informative) Notation of main parameters
Annex B (informative) Span pipe calculations

Specifies common requirements for the following components: concrete pressure pipes, joints and fittings including jacking pipes.