EN 13706-2:2002

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
  4.1 Appearance
  4.2 Dimensional tolerance
  4.3 Workmanship
5 Sampling
  5.1 General
  5.2 Certificate of Conformity
  5.3 Resolution of quality issues
6 Preparation of plates and test specimens
  6.1 Manufacture of test plates
  6.2 Preparation of specimens
  6.3 Profile full section test specimens
7 List of Properties
8 Labelling
Annex A (normative) - Visual Defects: Description and
                        Acceptance Levels (see also Annex C -
                        Workmanship
Annex B (normative) - Dimensional tolerances for pultruded
                        profiles
Annex C (normative) - Workmanship
Annex D (normative) - Determination of effective flexural
                        modulus
Annex E (normative) - Determination of the pin bearing
                        strength
Annex F (informative) - Recommended test methods for
                        particular requirements
Annex G (informative) - Determination of flexural, shear and
                        torsional stiffness properties
Bibliography

This Part 2 of ENxxxx defines the general requirements applicable to the specification of all types of pultruded profiles falling within the scope of this specification as defined in Part 1 of the standard. This Part 2 of ENxxxx describes the procedures to be followed in the preparation of test specimens for the determination of mechanical properties required for the designation in Part 1 and the technical specification in Part 3. This Part 2 of ENxxxx also defines the test methods to be used to determine both the designated and the specified properties given in Parts 1 & 3 respectively.