ASTM B 831 : 2019
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Shear Testing of Thin Aluminum Alloy Products
Hardcopy , PDF
30-01-2023
English
15-07-2019
Important note : All end users must be registered with an Account prior to user licenses being assigned.
This test method covers single shear testing of thin wrought and cast aluminum alloy products to determine shear ultimate strengths.
| Committee |
B 07
|
| DocumentType |
Test Method
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method covers single shear testing of thin wrought and cast aluminum alloy products to determine shear ultimate strengths. It is intended for products that are too thin to be tested according to Test Method B769.
1.2The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM E 238 : 2017 : REV A | Standard Test Method for Pin-Type Bearing Test of Metallic Materials |
| ASTM B 565 : 2020 | Standard Test Method for Shear Testing of Aluminum and Aluminum-Alloy Rivets and Cold-Heading Wire and Rods |
| ASTM E 2208 : 2002 : R2010 | Standard Guide for Evaluating Non-Contacting Optical Strain Measurement Systems |
| ASTM E 2208 : 2002 : R2010 : EDT 1 | Standard Guide for Evaluating Non-Contacting Optical Strain Measurement Systems |
| ASTM E 6 : 2002 | Standard Terminology Relating to Methods of Mechanical Testing |
| ASTM E 2208 : 2002 : R2018 : EDT 1 | Standard Guide for Evaluating Non-Contacting Optical Strain Measurement Systems |
| ASTM E 6 : 2015 : EDT 3 | Standard Terminology Relating to Methods of Mechanical Testing |
| ASTM E 4 : 2021 | Standard Practices for Force Calibration and Verification of Testing Machines |
| ASTM E 6 : 2015 : EDT 4 : REDLINE | Standard Terminology Relating to Methods of Mechanical Testing |
| ASTM B 769 : 2011 : R2021 | Standard Test Method for Shear Testing of Aluminum Alloys |
| ASTM E 2208 : 2002 | Standard Guide for Evaluating Non-Contacting Optical Strain Measurement Systems |
| ASTM B 769 : 2011 : R2016 | Standard Test Method for Shear Testing of Aluminum Alloys |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.